LE MAITRE Arctic Snow Machine Руководство по эксплуатации онлайн [4/8] 776773

Setup

● Remove all packing materials including foam and plastic padding and

place machine on a flat surface and follow step set up instructions.

● Assemble the hanging bracket on the machine, use the M8 screws to

position the hanging bracket with the machine, the tightening screws are

for adjusting the machine’s angle when in the air.

● Fill with Le Maitre Snow Fluid and replace cap.

● Firmly attach the 4-pin connector on the remote control cable to the proper

input on the rear of the machine.

Installation Note

● This unit can be installed at floor level or suspended overhead where it will

work at its best. When mounting the unit overhead, always ensure that the

unit is secure, connected by the cable wires passing the safety ring. Do

not angle at more than 15 degrees..

● Always monitor tank fluid level during operation as running the snow

Hanging Bracket

M8 Screw

Tightening

Screw

Washer

Assembling

Hanging

Bracket

Assemble 4 w ashers on both inner sides of the hanging

bracket w ith M8 screw s on outer sides as indicated.

Tank cap

Liquid

Tube

Adaptor

with

Nut

Filter

Tank

A ssembling Tan k & Filter

Please note that "adaptor w ith nut"

set must be tightly connected.