Tefal X-PLORER Serie 75 S RG8575WH [3/83] X plorer serie 75 s 75 s

Tefal X-PLORER Serie 75 S RG8575WH [3/83] X plorer serie 75 s 75 s
4 5
4 5
EN
be removed. To replace the batteries, contact your nearest
Approved Service Centre.
The batteries must be handled with care. Do not put
the batteries in your mouth. Do not let the batteries
come in contact with other metal objects such as
rings, nails or screws. Be careful not to provoke internal
short-circuits in the batteries by inserting metal
objects through their extremities. If a short-circuit
does occur, the temperature of the batteries could rise
dangerously, causing serious burns or even catching
fire. If the batteries are leaking, do not rub your eyes or
mucous membranes. Wash your hands and your rinse
eyes in clean water. If discomfort persists, contact your
doctor.
It is important that you remove the batteries before
throwing away your appliance. In order to do this,
visit an authorised Service Centre. Do not throw
the battery block into the waste bin; take it to the
authorised Tefal Service Centre nearest to your home
or to a place specially designated to process such
type of waste.
SAFETY GUIDELINES FOR MOPPING SYSTEM
Please refer to the instructions supplied with your robot vacuum cleaner
and the instructions supplied with this accessory so that you are aware of
the instructions for use.
Please take note of the following additions to the safety manual for using
this accessory.
TO BE READ BEFORE FIRST USE
Do not allow the robot vacuum cleaner to move over the power cable of other appliances or other types of
cables as this may result in danger.
Do not use any cleaning solutions on your robot vacuum cleaner; use water only. Fill the tank up to the
maximum level mark.
The cable must be disconnected from the power outlet before performing any maintenance or before cleaning
the appliance.
ENVIRONMENT
In accordance with existing regulations, any end-of-life appliances must be taken to an approved Service Centre
which will take responsibility for managing their disposal.
Let’s help protect the environment,
Your device is designed to work for many years. But when you decide to replace it, don’t forget
to think about how you can help protect the environment by allowing it to be reused, recycled
or recovered in some other way. Waste electrical and electronic equipment may contain harmful
substances that can cause harm to the environment and human health.
This label indicates that this product must not be disposed of with household waste. Take it to a collection point,
to the distributor when buying a new equivalent product, or an approved service center for processing.
Before disposing of the device, remove the battery and dispose of it in accordance with local laws and local
arrangements.
If you have any questions, please contact your product dealer who can tell you what to do.
EU SIMPLIFIED CONFORMITY DECLARATION
Groupe SEB declares that the radio equipment complies with the 2014/53/EU directive.
EU Declaration of Conformity’s full statement can be viewed at the following web address :
https://www.rowenta.fr/eu-declaration-of-conformity
Frequency band operated: 2400-2483.5 MHz
Maximum radio frequency power: 17 dBm@11b /14 dBm@11g /13 dBm@11n
Groupe SEB declares that the radio equipment complies with Regulation 801/2013.
The networked standby power consumption of the equipment is 1.9W.
Troubleshooting
X-plorer Serie 75 S & 75 S+
Fault Solution
The robot cannot start. Make sure that the main switch of the device is turned on.
- Make sure the robot is connected to power supply.
- Make sure the battery is fully charged.
The robot suddenly stops working. Check whether the robot is stuck or blocked by obstacles.
- Check whether the battery is too low.
- If the problem persists, please shut it down, wait for 3 seconds, and
then restart it.
Cannot make a sweep schedule Make sure the robot has been powered on.
- Set the time and schedule the time for automatic sweep with the
app.
- Make sure the schedule time has been set correctly.
- Check whether the machine power is too low to start sweep.
- The robot will not start any scheduled sweep when the task is being
performed.
Suction too weak Check the suction inlet for any obstruction.
- Empty the dustbin.
- Clean filters with water.
- Check whether filters are wet due to water or other liquids on the
floor. Let filters dry naturally thoroughly before use.

Содержание

Похожие устройства

Скачать
Случайные обсуждения

Ответы 0

мигают лампочки питания и домой
3 месяца назад