KRAFT Technology TCH-HDD8587SW [46/80] Automatic washing machine

KRAFT Technology TCH-HDD8587SW [46/80] Automatic washing machine
46
USER GUIDE
AUTOMATIC WASHING MACHINE
Washing machine draws and drains
water at the same time.
Check and make sure that the end of the drain hose is located above 100-
125 cm from the floor level.
The door lock is faulty.
Check that the clothes are not stuck between the drum and the door.
Remove the interference. Close the door tightly. Contact the service
center if necessary.
The heating element is faulty.
Close the water tap, disconnect the machine from electricity and water
supply. Contact the service center.
Water overflows.
The drum does not rotate.
Vibration in the washing machine.
Check and make sure that all the transport bolts are removed.
Adjust the position of the washing machine level in different planes.
There is a large amount of foam
through the compartments for
washing powder.
Reduce the dose of detergent.
Check the water hardness, as well as the amount and type of detergent
used.
Interrupting the washing process
until the end of the program.
Check the supply voltage, water supply, and water drain.
Check the supply voltage, water
supply, and water drain.
The washing machine is equipped with an automatic water top-up system.
The suspension is caused by the removal of excess foam.
ATTENTION! Troubleshooting that is not spelled out in this manual can only
be carried out by a qualied specialist.
In case of malfunctions that are not specified in this manual, you should immediately
contact an authorized service center, specifying the type of problem and the model of
your washing machine. Only original spare parts can be used for repairs. Unqualified
repair removes the device from warranty service.
SELF-DIAGNOSIS
The washing machine has an internal diagnostic system, which, in caseof minor mal-
functions associated with improper operation, helps to determine their causes.
Fault
codes
Fault type Possible cause / solutions
E02
No inlet water
Check whether the faucet is turned on? Whether the water supply is cut off? Whether mesh filter
in the water inlet hose and the water inlet valve are blocked? and whether the water inlet hose
of the appliance is frozen? Eliminate the above fault causes. if the fault code still exists, please
contact the service center for repair.
E03
Abnormal water
drainage
Clean the pump filter.
Check whether the drain hose is bent, twisted or blocked? Eliminate the above fault causes. If the
fault code still exists, please contact the service center for repair.
U4
Door lock
malfunction
The door is not closed in place, and the door lock does not work normally. Close the door again,
turn the wash cycle selector knob to the OFF position to turn off the power supply, and then turn
the wash cycle selector knob to select any wash program and press the START/PAUSE button
to restart the program. Eliminate this fault causes. If the fault code still exists, please contact the
service center for repair. If the fault code displays and cannot open the door, door lock may be
failure, please contact the service center for repair.
H
The temperature
in the drum is
high
Press the START/PAUSE button to suspend the appliance operation and wait for several
minutes. When the temperature in the drum drops to a safe range and the fault code on the
display is removed, press the START/PAUSE button to continue the rest of the program. If the
fault code still exists, please contact the service center for repair.

Содержание

Скачать