Vitek VT-3414 [12/40] English

Vitek VT-3414 [12/40] English
12
ENGLISH
To switch the unit on, press and hold down
the button (3).
After you finish using the unit, take the
power plug out of the mains socket, discon-
nect the whisk gear (8) from the motor unit
(2) by turning the gear (8) counterclock-
wise (pic. 3).
Remove the whisk (9) from the gear (8)
(pic. 2).
ATTENTION!
Do not use the whisk attachment (9) to
knead tight dough.
Put products into the bowl before switching
the unit on.
USING THE CHOPPER
The chopper is used to chop meat, cheese,
onion, herbs, garlic, carrots, walnuts, almonds,
prunes, vegetables and fruit.
ATTENTION!
Do not chop very hard products, such as ice
cubes, frozen products, nutmegs, coffee
beans, cereals etc.
Before you start chopping:
Cut meat, cheese, onions, vegetables or
fruit into pieces approximately 2x2 cm in
size.
Remove stems of herbs, shell nuts.
Remove bones, sinews and cartilage from
meat.
Chopping
Caution: the blades of the chopping knife (7)
are very sharp!
Always hold the chopping knife (7) by the upper
plastic end.
Place the chopper bowl (6) on a flat stable
surface.
Set the chopping knife (7) on the axis inside
the chopper bowl (6).
Put the products into the chopper bowl (6).
Note: Do not switch the unit on when the chop-
per bowl (6) is empty.
Place the geared lid (5) on the chopper
bowl (6) and turn it clockwise as far as it will
go (pic. 4).
Install the motor unit (2) on the geared
lid (5) feeding chute, turn the motor unit (2)
counterclockwise as far as it will go, make
sure that the motor unit (2) is fixed properly
(pic. 5).
Chopping
Caution: the blades of chopping knife (7) are
very sharp!
Always hold the chopping knife (7) by the up-
per plastic end.
Place bowl (1) on a flat stable surface.
Install the chopper knife (7) on the axle
inside bowl (6).
Put foods into bowl (11).
Note: do not turn on the appliance with empty
bowl (6).
Place geared lid (5) on chopper bowl (6)
and rotate it clockwise as far as it will go
(pic. 4).
Install the motor unit (2) on the geared lid
(5) feeding chute, turn the motor unit (2)
counterclockwise as far as it will go, make
sure that the motor unit (2) is fixed properly
(pic. 5).
Install the motor unit (2) strictly in the vertical
position and evenly.
Connect the appliance to mains by plugging
the power cord into a mains socket.
To switch the appliance on, press and hold
button (3).
During operation, hold motor unit (2) with
one hand and bowl (6) with the other hand.
After using the appliance, wait until chop-
ping knife (7) fully stops.
Remove the power plug from the mains
socket.
Detach motor unit (2) from geared lid (5)
feeding chute by turning motor unit (2)
clockwise (pic. 5).
Remove the geared lid (5) by turning it coun-
terclockwise (pic. 4).
Carefully remove the chopper knife (7) by
holding the plastic shank.
Remove chopped foods from bowl (6).
ATTENTION!
Strictly follow the described sequence of op-
erations.
For best results, refer to the table below:
Recipe Recommended
attachments
Weight,
amount
of foods
Cooking method Approximate
cooking time
Mayonnaise 250 ml Break 1 egg into a suitable container,
add salt, a few drops of vinegar or
lemon, pour the required amount of
vegetable oil. Switch the blender on
and mix the foods until the oil emulsi-
fies to the desired consistency.
35 sec.
Fruit cock-
tails
--- Place fruits in a suitable container
and grind them with a blender attach-
ment until a homogeneous mass is
obtained.
---
Bechamel
sauce
600 ml Melt 30 g butter in a casserole over
low heat, add 100 g flour and 30 g
fried onion (preliminarily chopped),
mix the ingredients and gradually add
500 ml milk.
15 sec.
Baby food 300 g Cut 100 g apples and 100 g banana,
crumble 50 g cookies with your hands
and put all the ingredients intoa suit-
able container, add some fruit juice
and mix to the desired consistency.
25 sec.
Whipped egg
whites
3 egg
whites
Add whites to a suitable container and
beat them with a whisk, making
movements up and down.
2 min

Содержание

Скачать