Fubag OL 231/50 CM 2 [9/15] Operator s manual

Содержание

• Cover 1 1
• Operator s manual 2
• Page01 2
• Page02 3
• Page03 4
• Operator s manual 5
• Page04 5
• Safety operation 5
• Caution 6
• Not to do 6
• Operator s manual 6
• Page05 6
• Operator s manual 7
• Page06 7
• Start up and use 7
• Technical specifications 7
• Air pressure can be regulated in order to optimize use of air powered tools operating on the knob 8
• Be used are compatible with the pressure set on the pressure regulator and with the amount of air supplied by the compressor 8
• Maintenance 8
• Operator s manual 8
• Page07 8
• Please check that the air consumption and the maximum working pressure of the pneumatic tool to 8
• Switch of the pressure switchis modified to use the compressor again wait at least 10 seconds after this has been switched off before restarting 8
• The compressor continues to operate automatically with this work cycle until the position of the 8
• The service life of the machine depends on maintenance quality before carrying out any operation always pull out the plug and drain the receiver completely fig 11 periodically or after working with the compressor for more than an hour drain the condensate that forms inside the receiver fig 11 due to the humidity in the air this protects the receiver from corrosion and does not restrict its capacity 8
• When you have finished working stop the machine pull out the plug and empty the reservoir fig 8
• With the valve open pulling it up and turning it in a clockwise direction to increase pressure and counterclockwise to reduce this fig 5 6 7 8 once you have set the value required push the knob down to lock it 8
• Operator s manual 9
• Page08 9
• Rub a g 9
• Troubleshooting 9
• Warranty 9
• Warranty refer to defects of materials and components and do not refer to components subject to natural wear and maintenance work only machines cleaned from dust and dirt in original factory packing fully completed provided with instruction manual warranty card with fixed sales date with a shop stamp factory serial number and originals of sales and ware receipt issued by salesman are subjects of warranty within the warranty period the service center eliminate free of charge all detected production defects the manufacturer disclaims warranty and legal responsibilities if nonobservance of the instruction manual by user unqualified disassembling repair or maintenance of the machine as well does not bear responsibility for caused injury to persons or damages 9
• Page09 10
• Инструкция по эксплуатации 10
• Правила безопасности 10
• Page10 11
• Важно 11
• Гиьад 11
• Запрещается 11
• Инструкция по эксплуатации 11
• Page11 12
• Инструкция по эксплуатации 12
• Ипад 12
• Пуск и эксплуатация 12
• Технические характеристики 12
• Page12 13
• Инструкция по эксплуатации 13
• Техническое обслуживание 13
• Page13 14
• Гарантийные обязательства 14
• Инструкция по эксплуатации 14
• Неисправности и способы их устранения 14
• Шрад 14
• Cover 2 15

Похожие устройства

• Patriot WO 100-440 525301935 Инструкция к товару
• Patriot WO 180K 525301905 Инструкция
• P.I.T. СТАНДАРТ GCS-52-D Инструкция к P.I.T. СТАНДАРТ GCS-45-D
• Patriot WO 50-300 525301925 Инструкция по эксплуатации
• ПКБ АРМА БП-ТВ3500-2 А522-3501 Инструкция по эксплуатации
• ABAC B6000 500T 62UW805KQA073 (4116020400) Инструкция по эксплуатации
• Fini AMICO 25/2400 100540241 Инструкция
• Fini MK-103-150-3M 100049765 Инструкция по эксплуатации
• Кедр КП-360/100 PRO 8023708 Руководство по эксплуатации КЕДР КП-360-100 PRO
• Кедр КП-480/100 PRO 8023709 Руководство по эксплуатации КЕДР КП-360-100 PRO
• Osram 100PSI 30 л/мин, 10 А, 12 В OTI200 Инструкция к товару
• Rossvik 1400л/мин, 10бар, ресивер 500л, 380В/7,5кВт СБ4/Ф-500.LТ100 Деталировка
• Rossvik 1400л/мин, 10бар, ресивер 500л, 380В/7,5кВт СБ4/Ф-500.LТ100 Инструкция
• Сорокин ресивер 100 л 13.6 Технический паспорт
• RedVerg Basic GC-45C 6672714 Инструкция к REDVERG Basic GC-45C 6672714
• POWER TECHNIC с фильтром влагоотделителем ACL200/008 Гарантийный талон
• Aurora AIR-25 6763 Инструкция по эксплуатации
• Aurora WIND-25 6762 Инструкция по эксплуатации
• ELSEN 1/2", В EPR01.1212 Инструкция к ELSEN EPR01.1212
• Patriot PTR 100-440I 525301965 Инструкция по эксплуатации

rub a g Operator s manual www fubag ru 5 Troubleshooting Request the assistance of a qualified electrician for operations on electric components cables motor pressure switch electric panel etc FAULT CAUSE REMEDY Leakage of air from the valve of the pressure switch with the compressor off Check valve that due to wear or dirt on the seal does not perform its function correctly Unscrew the hexagonal head of the check valve clean the valve seat and the special rubber disk replace if worn Reassemble and tighten carefully figures 9 10 Reduction of performance Frequent start up Low pressure values Excessive performance request check for any leaks from the couplings and or pipes Intake filter may be clogged Replace the seals of the fitting The compressor stops and restarts automatically after a few minutes Tripping of the thermal cutout due to overheating of the motor Clean the air ducts in the conveyor Ventilate the work area Reset the thermal cutout On lubricated check oil level and quality After a few attempts to restart the compressor Tripping of the thermal cutout due to overheating of the motor Activate the on off switch Ventilate the work area Wait a few minutes The compressor will restart independently Remove any power cable extensions The compressor does not stop and the safety valve is tripped Irregular functioning of the compressor or breakage of the pressure switch Remove the plug and contact the Service Center Any other type of operation must be carried out by authorized Service Centers requesting original parts Tampering with the machine may impair its safety and in any case make the warranty null and void 6 Warranty Warranty refer to defects of materials and components and do not refer to components subject to natural wear and maintenance work Only machines cleaned from dust and dirt in original factory packing fully completed provided with instruction manual warranty card with fixed sales date with a shop stamp factory serial number and originals of sales and ware receipt issued by salesman are subjects of warranty Within the warranty period the service center eliminate free of charge all detected production defects The manufacturer disclaims warranty and legal responsibilities if nonobservance of the instruction manual by user unqualified disassembling repair or maintenance of the machine as well does not bear responsibility for caused injury to persons or damages