REMEZair RMVС-553 AquaStream Pro ЦБ-00000299 [13/20] Fault code table
![REMEZair RMVC-553 AquaStream Pro [13/20] Fault code table](/views2/1850327/page13/bgd.png)
ENG
FAULT CODE TABLE
Error code Reasons Solutions
Е1 Battery disconnected Replace the battery
Е2 Battery voltage too low Replace the battery
Е3 The voltage of the battery cells
is different
Replace the battery
Е4 Battery temperature control
abnormal
Replace the battery
Е5 High battery temperature
during discharge
The battery is overheated, do not use the
appliance until the battery temperature
returns to normal
Е6 High battery charging tem-
perature
The battery is overheated, do not use the
appliance until the battery temperature
returns to normal
Е7 Low battery temperature
when charging
Make sure the ambient temperature is
above 5°C
F1 Battery recharge Make sure you are using the original
charger
F2 Short circuit protection
tripped
Contact the specialists of the Service
Center
F3 Increased current consump-
tion
Contact the specialists of the Service
Center
F4 Increased roller brush con-
sumption
Make sure that there are no foreign
objects in the roller brush that block the
brush or impede its movement. If the
error persists, contact the Service Center
specialists
F6 Waste water tank is not
installed
Install dirty tank before use
Water droplets appear
at the turbine outlet
• The HEPA filter is not
installed
• The HEPA filter is not
completely dry
• The body of the vacuum
cleaner is strongly inclined
• The vacuum cleaner has
collected a lot of foam
• Check and install the HEPA
filter.
• Dry HEPA -filter prior to use.
• Hold the vacuum cleaner at the
correct angle.
• Clean the dirty water tank
promptly.
The vacuum cleaner is
difficult to move
• The roller brush is not
installed correctly
• Check and reinstall the
roller brush according to the
instructions
The indicator shows
that the dirty water
tank is full while it is
empty
• The vacuum cleaner is
collecting too much foam
• Clean the dirty water tank
Содержание
- Aquastream pro 1
- Bedienungsanleitung 1
- Rmvc 553 1
- User manual 1
- Беспроводной моющий пылесос cordless washing vacuum cleaner kabelloser waschsauger 1
- Руководство пользователя 1
- Меры предосторожности 2
- Охрана окружающей среды 2
- Правила техники безопасности при использовании аккумулятора 2
- Предупреждение 2
- Схема устройства комплектация прибора 3
- Дисплей 4
- Значения дисплея цветовой индикатор 4
- Подача чистой воды 4
- Примечание по наполнению резервуара для чистой воды 4
- Разборка и установка ручки 4
- Сборка устройства 4
- Управление голосовым помощником 4
- Управление моющим пылесосом 4
- Установка и заполнение резервуара для чистой воды 4
- Для очищения ковров или ковровых покрытий используйте роликовую щётку для ковров которая входит в комплект 5
- Рус 5
- Установите прозрачную крышку для роликовой щётки предварительно выровняв имеющиеся на ней язычки по пазам основной насадки как показано на рисунке вставьте язычки в пазы и нажмите на защёлку прозрачной крышки до щелчка 5
- Установите роликовую щётку вставив её сначала в правую часть основной насадки а затем слегка нажмите на выступ чтобы зафиксировать 5
- Установка прозрачной крышки для роликовой щётки 5
- Установка роликовой щётки 5
- Установка станции для зарядки и самоочистки 5
- Уход за резервуаром для грязной воды 5
- Поиск и устранение неисправностей 6
- Проблема возможные причины решения 6
- Режим бесконтактной трехступенчатой самоочистки 6
- Технические характеристики 6
- Таблица кодов неисправностей 7
- Environment protection 8
- Safety measures 8
- Safety rules for using the battery 8
- Warning 8
- Product components 9
- Assembling the appliance 10
- Clean water spray 10
- Control of the washing vacuum cleaner 10
- Disassembly and installation of the handle 10
- Display 10
- Display values colour indicator 10
- Installation and filling of the clean water tank 10
- Notes on filling the clean water tank 10
- Turning on off of the voice assistant 10
- Dirty water tank maintenance 11
- Install the roller brush by first inserting it into the right side of the main brush and then pressing lightly on the tab until it locks in place 11
- Install the transparent roller brush cover after aligning the tabs on it with the grooves of the main nozzle as shown in the figure insert the tabs into the slots and press the latch on the transparent cover until you hear a click 11
- Installation of a charging and self cleaning station 11
- Installation of the transparent cover for the roller brush 11
- Installing the roller brush 11
- Use the supplied roller carpet brush to clean carpets or carpets 11
- Non contact three stage self cleaning mode 12
- Problems possible reasons solutions 12
- Specifications 12
- Troubleshooting 12
- Fault code table 13
- Sicherheitsmassnahmen 14
- Sicherheitsvorschriften für die verwendung der batterie 14
- Umweltschutz 14
- Warnung 14
- Lieferumfang produktübersicht 15
- Demontage und montage des griffs 16
- Display 16
- Ein ausschalten des sprachassistenten 16
- Hinweise zum befüllen des reinwassertanks 16
- Montage und befüllung des reinwassertanks 16
- Reinwasserzulauf 16
- Steuerung des waschsaugers 16
- Werte des displays farbindikator 16
- Zusammenstellen des gerätes 16
- Montage der station zum aufladen und zur selbstreinigung 17
- Montage der walzenbürste 17
- Montage des transparenten deckels für die walzenbürste 17
- Montieren sie den transparenten deckel der walzenbürste nachdem sie die laschen darauf mit den rasten der hauptdüse ausgerichtet haben wie es in der abbildung gezeigt ist stecken sie die laschen in die rast und drücken sie auf die verriegelung der transparenten abdeckung bis sie ein klicken hören 17
- Montieren sie die walzenbürste indem sie sie zuerst in die rechte seite der hauptdüse einführen und dann leicht auf den vorsprung drücken bis die bürste befestigt ist 17
- Verwenden sie die mitgelieferte teppichwalzenbürste um teppiche oder teppiche zu reinigen 17
- Wartung des schmutzwassertanks 17
- Berührungsloser dreistufiger selbstreinigungsmodus 18
- Fehlersuche und beseitigung 18
- Probleme mögliche ursachen lösungen 18
- Technische daten 18
- Fehlercodetabelle 19
Похожие устройства
- Gigant 4D 16 линий GBLL-10 Инструкция к товару
- Gigant 4D 16 линий + штатив 1.6 м GBLL-9 Инструкция к товару
- Gigant 4D 16 линий + телескопическая штанга 3.6 м + штатив 1.5 м GBLL-6 Инструкция к товару
- LT L16-360B + штатив 4.8 м + тренога 1.5 м усиленная + приемник (отражатель) лазерного луча L16-360B/4.8м/1.5м-УС/ОТР Инструкция
- LT L16-360S + штатив 4.8 м L16-360S/4.8м/1.6м Инструкция
- LT L16-360S + штатив 4.8 м + тренога 1.5 м усиленная + приемник (отражатель) лазерного луча L16-360S/4.8м/1.5м-УС/ОТР Инструкция
- LT L16-360S + штатив с треногой 4.8 м L16-360S/4.8м+ Инструкция
- LT L16-360S/ОТР Инструкция
- LT L16-360Z + штатив 4.8 м L16-360Z/4.8м/1.6м Инструкция
- LT L16-360Z + штатив 4.8 м + тренога 1.5 м усиленная + приемник (отражатель) лазерного луча L16-360Z/4.8м/1.5м-УС/ОТР Инструкция
- LT L16-360Z + штатив с треногой 4.8 м L16-360Z/4.8м+ Инструкция
- LT 4D L16-360S Инструкция
- LT L12-360A L12-360A/1м Инструкция
- LT L16-360A Инструкция
- LT L16-360А + тренога 1.5м усиленная L16-360A/1.5м-УС Инструкция
- LT L16-360А + тренога 1.6м L16-360A/1.6м Инструкция
- LT L16-360М + тренога 1.6м L16-360M/1.6м Инструкция к товару
- LT L16-360S + штанга распорная 3.6м L16-360S/3.6м Инструкция
- LT L16-360S + штатив 3.6м + тренога 1.5м усиленная L16-360S/3.6м/1.5м-УС Инструкция
- LT L16-360Z 4D 16 линий + штатив 1.6 м L16-360Z/1.6м Инструкция