Monsher MOE 4592 черный/нержавеющая сталь [44/0] Installation instructions important note

English

Oven Light Replacement

The light used in oven is a special high temperature resistant light (AC220V/25W).

Therefore, it is necessary to purchase genuine light from authorized distributors.

The replacement steps are as follows:

1. Disconnect the power supply of the power socket.

2. Turn the glass cover counterclockwise.(Figure 5)

3. Remove the light and replace it with the same type.(Figure 6)

4. After replacing the light, screw the glass cover clockwise.

Figure 5 Figure 6

Sensor Probe Replacement

The probe used in the oven is a mechanical physical probe. Do not replace it without

authorization. In case of abnormal temperature sensing of the sensor probe, please

contact the designated repair shop immediately for replacement.

INSTALLATION INSTRUCTIONS

Important note

For installation personnel

; The kitchen cover must be suitable to ensure that the oven works properly.

; The panel of kitchen equipment adjacent to the oven must be made of heat-resistant

materials. Kitchen equipment made of plywood shall ensure that the glue can withstand

a temperature of at least 120 degrees Celsius. When plastic or glue cannot withstand

this temperature, the equipment will melt and deform.

; Once the oven is placed in the kitchen equipment, the electrical components must be

completely insulated. This is a statutory safety requirement.

; All furnace covers must be firmly fixed in place and cannot be removed without using

special tools.

; Remove the back of the kitchen equipment to ensure the full circulation of air around

the oven.

; The oven rack must have at least 45 mm rear clearance.