Vdo Z3 PC [48/65] Instruction manual

INSTRUCTION MANUAL

- All pulse data (only under certain conditions in walk mode)

- Lap data if lap timer is used

- All cadence data (if the cadence kit is installe

Note:

If you are using the lap timers the lap data will have a ﬂag. When trans-

ferring data from the computer to the PC the lap data are identiﬁed via

this ﬂag and are displayed and analyzed separately in the PC-Sport

program.

IMPORTANT INFORMATION PLEASE NOTE THE FOLLOWING:

a. The storage capacity of the device is conﬁgured for a total of 100

training hours.

b. After this total time is exceeded the new data automatically over-

writes the oldest data in the memory.

c. A manual delete of training data is not possible.

d. Due to the recording interval of 10 or 20 sec. there may be slight

deviation between the data in your VDO computer and the data in the

PC-Sport program (e.g. average pulse)

TIPP: Connect your VDO computer to your PC at regular intervals so that

important data is not overwritten. Manual control/read out of the data

records of the DATA RECORDING and a data delete is not possible on

your VDO computer itself.

15.1. STARTING/STOPPING DATA RECORDING

You must start data recording manually:

Start data recording:

Press ≈ ç concurrently Start of data recording

REC is displayed in the center

bar

End data recording:

Press ≈ ç concurrently Stop data recording

REC is not illuminated

What happens when I take a break?

If you take a break during DATA RECORDING, and the computer goes

into SLEEP MODE after 5 minutes (chapter 16) then DATA RECORDING

will be interrupted automatically. If SLEEP MODE is ended by pressing a

button then DATA RECORDING will be automatically continued.

TIP: Leave your VDO computer on the handlebar holder so that sleep

mode is activated and recording is interrupted automatically after 5

minutes (see chapter 16 Sleep mode).

ATTENTION: If you manually interrupt data recording, for a break for

example by pressing ≈ ç , then a new data record will be generated

at restart. Even if you do a trip data reset during „DATA RECORDING“

your VDO computer will generate a new data record.

DATA RECORD