Asko D5436 S [8/24] Stopping or changing a program

NOTE!

During the first run of each program, the remaining time dis-

played can be slightly misleading, as the dishwasher is estimat-

ing the time. When you run the program a second time, the

dishwasher will calculate the remaining time based on the

previous duration of the program.

Stopping or changing a program

In order not to accidently press a button and cancel the current

program, you must press and hold Start/Stop for five seconds if

you want to change programs after starting the dishwasher. Add

more detergent if the lid of the detergent dispenser has opened.

Then choose a new program and press Start/Stop.

Do you want to add more dishes?

Open the door. The dishwasher stops automatically. Add the

dishes, close the door and the dishwasher continues the program.

If the dishwasher is turned off using

the main power switch or due to a

power failure

If the dishwashing program was not finished, the interrupted

program continues when power is restored.

NOTE!

During drying, the program is interrupted if the power is cut or

the door is open for more than 2 minutes.

Once the program has finished

Once the program has finished, “End” appears on the display.

At the end of the program, you will hear a short beep. Chapter

Settings describes how to change this function.

Once the dishwasher has finished, it only uses standby power.

Turn off the dishwasher with the main power switch if you want

to cut the power completely. Shut off the water supply valve after

every use.

Drying

For additional drying the door should be opened 35 mm upon

completion of the drying cycle. For more information, see page

16 in the chapter Technical information.