Alpina T 1.0 EJ 223536 [23/258] Preparing to work
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Alpina T 1.0 EJ 223536 [23/258] Preparing to work

Alpina T 1.0 EJ 223536 [23/258] Preparing to work
2. ELECTRICAL CONNECTIONS
Electricity and moisture
are not compatible.
– Always handle and connect electric cables
in dry conditions.
– Keep electric sockets or cables away from
wet and damp areas (e.g. puddles or wet
ground).
The quality of the extension leads must be no less
than H07RN-F or H07VV-F, with a minimum sec-
tion of 1.5 mm and a recommended maximum
length of 30 m.
To avoid overheating, do not keep the extension
lead rolled up during use.
The permanent connec-
tion of any electrical equipment to the mains of
a building must be installed by a qualified
electrician in conformity with the regulations in
force. Incorrect wiring can cause serious in-
jury and even death.
DANGER!
DANGER!
1. CHECKING THE MACHINE
Make sure the machine is
not plugged into the mains socket.
Before starting work please:
– check that the mains frequency and voltage is
the same as the rating data on the “Identification
Plate” (see chap. 1 - 11.8).
– check that the trigger switch and the safety but-
ton should move freely without forcing and return
automatically and rapidly back to their neutral po-
sition;
– Check that the trigger switch must remain locked
until the safety button is pressed;
– check that the cooling air vents are not ob-
structed;
– check that the power cable and extension lead
are not damaged;
– check that handgrips and protection devices are
clean and dry, correctly mounted and well fas-
tened to the machine;
– check that the cutting devices and guards are not
damaged;
– check that the machine is not showing signs of
wear or damage due to knocks or other causes,
and carry out the necessary repairs.
WARNING!
PREPARING TO WORK / HOW TO START - STOP THE MOTOR
7
EN
5. PREPARING TO WORK
When you release the
switch, the safety button is also released and the
motor stops.
STOPPING THE MOTOR (Fig. 4)
To stop the motor:
– Release the switch (6).
– FIRST unplug the extension lead (3) from the
mains socket (4) and THEN disconnect the
power cable (2) of the machine from the exten-
sion lead (3).
NOTE
STARTING THE MOTOR (Fig. 4)
Before starting the motor:
– Fasten the extension lead (1) to the cable clamp
on the rear handgrip.
– FIRST connect the power cable plug (2) to the
extension lead (3) and THEN plug the exten-
sion lead into the mains socket (4).
To start the motor:
– Hold the machine firmly with both hands.
– Press the safety button and then the switch (6).
6. HOW TO START - STOP THE MOTOR

Содержание

Похожие устройства

Скачать