![Suunto HelO2 [18/64] Transmitting data](/img/pdf.png)
Suunto HelO2 [18/64] Transmitting data
![Suunto HelO2 [18/64] Transmitting data](/views2/1013589/page18/bg12.png)
2.
Ensure that the Suunto HelO
2
is turned on, and that the wireless integration is enabled
in the Suunto HelO
2
settings (HP set ON, see Section 5.9.8. Setting the HP code).
The HelO
2
should display “cd:--” in the lower left corner of the alternative display.
3.
Slowly open the cylinder valve fully and pressurize the regulator. The transmitter starts
transmitting when the pressure exceeds 15 bar/218 psi.
4.
Take the Suunto HelO
2
wrist unit close to the transmitter. The unit will then quickly
display the selected code number and then start displaying the transmitted cylinder
pressure. The wireless transmitter indicator is displayed every time the Suunto receives
a valid signal.
WARNING
If there are several divers using Suunto HelO
2
with wireless transmis-
sion, always ensure that each diver is using a different code before
starting the dive.
You can manually change the transmitter’s code by reducing the
pressure to less than 10 bar/145 psi and then immediately (within 10-
12 seconds) increasing the pressure to above 15 bar/220 psi.
Reset the transmitter's code manually, see Section 5.9.8. Setting the
HP code.
The transmitter will then select a new code. The Suunto HelO
2
must
be in “cd:--“ mode to pair on the new code. This procedure can be
used if, for example, your dive buddy has the same code and you
need to change it.
NOTE
In order to save battery energy, the transmitter shuts off if the pressure
remains unchanged for more than 10 minutes, and it will continue
transmitting with the saved code when any pressure change is
measured.
5.8.3. Transmitting data
After the pairing procedure, the Suunto HelO
2
will receive cylinder pressure data from the
transmitter. The pressure is displayed in either bars or psi, depending on the unit selected.
Any time the Suunto HelO
2
receives an appropriate signal it flashes the wireless transmitter
indicator in the display’s lower left corner.
Table 5.3. Pressure transmission related displays
FigureIndicationDisplay
A
Set Code. No code stored, Suunto HelO
2
ready for pairing with trans-
mitter.
Cd:--
B
Pressure reading over 360 bar/5220 psi.
- - -
C
Pressure reading has not been updated for more than one minute.
The latest valid pressure reading is displayed intermittently. After five
minutes, "FAIL" is displayed intermittently with "---".
Transmitter is out of range, in power saving mode or on another
channel. Activate the transmitter by breathing off the regulator, and
recode the wrist unit if necessary.
FAIL
D
Pressure transmitter battery voltage is low. The pressure reading is
displayed intermittently. Change the transmitter battery!
LOb
E
Pairing has not been conducted between the dive computer and the
transmitter before start of dive. No cylinder data available.
OFF
18
Содержание
- Suunto helo2 user s guide 1
- User s guide 1
- Table of contents 3
- Using helo2 with dive manager and dive planner 5
- Welcome to the world of suunto diving instruments 5
- Warnings cautions and notes 6
- Button symbols and functions 9
- Navigating in the menus 9
- Suunto helo2 at a glance 9
- Getting started with your suunto helo2 11
- Setting the date 11
- Setting the time 11
- Setting the units 11
- Time mode settings 11
- Ac water contacts 12
- Setting the backlight 12
- Setting the tones 12
- Before diving 13
- Planning your dives 13
- The suunto technical rgbm 13
- Dive computer limitations 14
- Emergency ascents 14
- Mixed gas diving 14
- Audible and visual alarms 15
- Error conditions 16
- Installing the wireless transmitter 17
- Pairing and code selection 17
- Wireless transmission 17
- Transmitting data 18
- Mixed gas dive mode settings 19
- Setting the gases 19
- Setting the depth alarm 20
- Setting the dive time alarm 20
- Setting the personal altitude adjustments 20
- Setting the hp code 21
- Setting the sample rate 21
- Setting the tank pressure 21
- Setting the tank pressure alarm 21
- Accessing dive mode 22
- Activation and pre checks 22
- Dive mode activation 22
- Setting the units 22
- Battery power indication 23
- Diving at altitude 23
- Personal adjustments 24
- Mandatory safety stops 25
- Recommended safety stops 25
- Safety stops 25
- Deep stops 26
- Basic dive data 27
- Diving 27
- Diving related information 27
- Ascent rate indicator 28
- Bookmark 28
- Decompression dives 28
- Safety stops 28
- Ceiling ceiling zone floor and decompression range 29
- Display above the ceiling 30
- Display above the floor 30
- Display at the ceiling zone 30
- Display below the floor 30
- Before diving in mixed gas mode 31
- Default gas mix settings 31
- Diving in mixed gas mode 31
- Oxygen and helium displays 31
- Gas change and multiple breathing gas mixes 32
- Oxygen limit fraction olf 32
- Diving in gauge mode 33
- After diving 34
- Dive numbering 34
- Surface interval 34
- Dive planning mode plannodec 35
- Flying after diving 35
- Plan mode 35
- Repetitive dive planning 35
- Dive numbering shown during dive planning 36
- Memory mode 36
- Dive logbook memlogbook 37
- Dive history 38
- Suunto dive planner sdp 38
- Suunto dive manager sdm 39
- Www suuntosports com and suunto diving world at www suunto com diving 39
- Care and maintenance of my suunto diving computer 41
- Battery kit 43
- Battery replacement 43
- Replacing the battery 43
- Required tools 43
- Battery 44
- Battery compartment lid with buzzer 44
- Battery retainer 44
- O ring 44
- Securing ring 44
- Wireless transmitter battery replacement 44
- Replacing the transmitter battery 45
- Required tools 45
- Transmitter battery kit 45
- Technical data 47
- Technical specifications 47
- Diver safety and suunto technical rgbm model 49
- Suunto technical rgbm decompression model 49
- Altitude diving 50
- Oxygen exposure 50
- Copyright 51
- Intellectual property 51
- Patent notice 51
- Trademark 51
- Disclaimers 52
- User s responsibility 52
- Suunto limited warranty for suunto diving com puters and suunto diving computer accessories 53
- Suunto limited warranty for suunto diving computers and suunto diving computer accessories 53
- Disposal of the device 56
- Glossary 57
- Copyright 59
- Customer service contacts 59
- Two year warranty 61
Похожие устройства
- D-Link DSL-500T Инструкция по эксплуатации
- Viking VH 660 Инструкция по эксплуатации
- JVC TH-S3 Инструкция по эксплуатации
- Elikor Europa 60 черный (290) пп Инструкция по эксплуатации
- Zelmer 886.5 BE Инструкция по эксплуатации
- Suunto Gekko Инструкция по эксплуатации
- Yamaha PSR-1500 Инструкция по эксплуатации
- D-Link DSL-200 (v.B1) Инструкция по эксплуатации
- Sungarden T250 BR 5.0 Инструкция по эксплуатации
- JVC TH-M45 Инструкция по эксплуатации
- Elikor Europa 50 черный (290) пп Инструкция по эксплуатации
- JVC TH-A9R Инструкция по эксплуатации
- Suunto D9tx Инструкция по эксплуатации
- Dekok UKA-1223 Инструкция по эксплуатации
- Yamaha PSR-175 Инструкция по эксплуатации
- Texas Lilli 532 B Инструкция по эксплуатации
- D-Link DSL-300T Инструкция по эксплуатации
- JVC TH-A85 Инструкция по эксплуатации
- Suunto D9 Инструкция по эксплуатации
- Yamaha PSR-295 Инструкция по эксплуатации