Suunto Cobra2 [26/56] Basic dive data

6. DIVING

This section contains instructions on how to operate the dive computer and interpret its

displays. You’ll find that this dive computer is easy to use and read. Each display shows

only the data relevant to that specific diving mode.

6.1. Diving in AIR mode (DIVEair)

In this section, we look at how to make the most of the dive computer when diving with

standard air. To activate DIVEair mode, please see Section 5.9.1. Accessing DIVE mode.

DIVE HAS JUST BEGUN AND

AVAILABLE NO-DECOMPRESSION

TIME IS OVER 99 MINUTES SO NO

VALUE IS DISPLAYED.

NOTE

The dive computer will remain in the Surface mode at depths less

than 1.2 m/4 ft. At depths greater than 1.2 m/4 ft the instrument will

go into the DIVE mode automatically. However, it is recommended

that you activate the DIVE Mode manually in order to perform the

necessary dive pre-checks.

6.1.1. Basic dive data

During a No-decompression dive, the following information is displayed:

•

your present depth in meters/feet

•

the available no-decompression time in minutes as NO DEC TIME

•

the ascent rate presented as a bar graph on the right side

•

the Diver Attention Symbol if surface interval should be prolonged (see Table 7.1,

Alarms)

DIVE DISPLAY - PRESENT DEPTH IS 15 M,

NO-DECOMPRESSION STOP TIME LIMIT IS 38 MIN.

ELAPSED DIVE TIME IS 13 MIN. 99 MINUTES OF

REMAINING AIR TIME AND 202 BAR TANK PRESSURE.

Alternative displays, by pressing the UP/DOWN buttons, show:

•

the elapsed dive time in minutes, shown as DIVE TIME

•

the water temperature in °C/°F

•

the maximum depth during this dive in meters/feet, indicated as MAX

•

the current time, shown as TIME

DOWN BUTTON TOGGLES

BETWEEN MAXIMUM DEPTH

AND CURRENT TIME.