Gorenje WHT68INI [9/69] Strona 9

1. Mechanical control cooperates with the electronics assembly – it serves only as a control panel. The electronics assembly

is responsible for activation of the motor’s power supply.

2. By turning the wing knob clockwise from position 0 to position 1, the motor goes into first gear and stays in first gear until this

position is altered manually. Reverse action reverts the settings to their previous state – gear 0.

3. By turning the wing knob clockwise from position 1 to position 2, the motor goes into second gear and stays in second gear

until this position is altered manually. Reverse action reverts the settings to their previous state – gear 1.

4. By turning the wing knob clockwise from position 2 to position 3, the motor goes into third gear and stays in third gear until

this position is altered manually. Reverse action reverts the settings to their previous state – gear 2.

5. By turning the wing knob clockwise from position 3 to position P, the motor goes into fourth gear and stays in fourth gear for

five minutes, unless this position is altered manually within that time. Once 5 minutes passes, the motor returns to gear 3.

When the device operates in the Automatic mode, the light indicator lights up white.

Maintenance

ATTENTION! Before performing any maintenance operation, isolate the hood from the electrical supply by switching off at the

connector and removing the connector fuse.

Or if the appliance has been connected through a plug and socket, then the plug must be removed from the socket.

Cleaning

The cooker hood should be cleaned regularly (at least with the same frequency with which you carry out maintenance of the fat

filters) internally and externally. Clean using the cloth dampened with neutral liquid detergent. Do not use abrasive products.

DO NOT USE ALCOHOL!

WARNING: Failure to carry out the basic cleaning recommendations of the cooker hood and replacement of the filters may cause

This must be cleaned once a month (or when the filter saturation indication system – if envisaged on the model in possession –

indicates this necessity) using non aggressive detergents, either by hand or in the dishwasher, which must be set to a low

temperature and a short cycle.

When washed in a dishwasher, the grease filter may discolour slightly, but this does not affect its filtering capacity.

To remove the grease filter, pull the spring release handle.

Replacing lamps

Disconnect the hood from the electricity.

Warning! Prior to touching the light bulbs ensure they are cooled down.

1. Remove the bulb halogen

2. Replace burned-out light bulb. Use only the contribution GU10 bulbs. After replacing the bulb needs to be cleaned.