Caiman VAL6 GN5 [11/24] Safety information
![Caiman VAL6 GN5 [11/24] Safety information](/views2/1150161/page11/bgb.png)
6
Safety Information
Make sure
the ame is
extinguished and
the power off
before leaving
the heater
unattended
After shutting off the heater, make sure that the ame is extinguished and the
power disconnected before leaving the heater unattended. It is also not safe
to leave the heater unattended while it is cooling off or to leave it in any area
where children are present or could come near the heater.
Do not dispose
of the heater
illegally
When disposing of the heater, please do not dispose of it illegally, but consult
your local authorities or specialists on how to properly dispose of it.
Do not use the
heater in the
following places
or conditions
To prevent accident or injury, do not use the heater in the following places or
under the following conditions:
• On vibrating, trembling, or unstable ooring
• On ladders, scaffolds, or sawhorses
• On any oor that is slanted, sloped, or not level
• On stairs or anywhere where it might block access to emergency exits
• Near unstable or stacked materials
• In windy, humid, or dusty areas, and areas where metal particles are present
• In areas where the ow of people or vehicles is impeded or obstructed
Always use caution in determining where to place the heater for use or
storage and take into account both present and potential future dangers.
Do not use the
heater in an
environment
subject to
corrosive gas.
Do not use the heater in an environment subject to corrosive gas.
Parts can become corroded and cause unit to operate improperly.
Do not operate
in extreme
temperatures
Make sure that the heater operates at temperatures between 14 ºF and 86
ºF (-10 ºC and 30 ºC). If the heater operates at more than 86 ºF (30 ºC), the
heater will overheat and could cause a re.
Transfer the
Owner’s Manual
to the new owner
If the heater is sold or given to a new owner, make sure that this Owner’s
Manual is transferred to the new owner along with the heater.
Keep away from
children
The heater should not be used, cooled, or stored where children could have
access to it. The heater should not be ignited, operated, maintained, attended
to, or otherwise used in any way by children.
Children or the
handicapped are
not to operate this
heater
This heater is not to be operated by children or the physically handicapped
or persons lacking proper knowledge and experience unless they have been
given proper supervision or instruction.
Never look
directly into the
radiation disk
While the heater is in operation, avoid looking directly into the radiation disk
as this could cause eye injury.
Hose assembly
must be
inspected before
each use
The hose assembly should undergo visual inspection prior to each use of the
heater. If excessive abrasion or wear is evident, or the hose is cut, the hose
assembly must be replaced prior to operation of the heater. The replacement
hose assembly should be equipment specied by Shizuoka Seiki.
Содержание
- Failure to comply with the instructions precautions and 1
- Important 1
- Infrared gas heater 1
- General hazard warning 2
- Warning 2
- Caution means that failure to follow the given precaution s may result in serious injury and or property damage 3
- Danger means that failure to follow the given precaution s may lead to death serious injury and or major fire 3
- Important manual information 3
- Warning means that failure to follow the given precaution s may likely result in death serious injury fire and or possible explosion 3
- Important manual information 4
- Location of safety labels 5
- Main components 5
- Maintenance 6 5
- Operation 0 5
- Safety devices 0 5
- Safety information 5
- Specifications 5
- Storage 8 5
- Table of contents 5
- Trouble recovery 8 5
- Airpurge or firing cooling 6
- Caution 6
- Keep heater away from flammable materials maintaining a distance of at least 8 feet 2 meters do not use heater in places exposed to rain snow or high temperatures should only be used with non combustible flooring never move heater while in operation heater may still be hot after it is turned off immediately discontinue use of the heater in case of any irregularities make sure the operating lamp is off before removing the electric plug be sure to properly position heater prior to use for indoor use only adequate ventilation must be provided at all times the hose assembly should be protected from traffic building materials and contact with hot surfaces both during use and while in storage never touch or adjust the air intakes of the burner fan motor to avoid severe burns and electrical shock never adjust the angle of the main unit while the heater is plugged in operating or still hot be sure to take hold of the burner grip when setting the angle of the main unit be sure to attach the fil 6
- Location of safety labels 6
- Mean action 6
- Misfire fuel empty or air 6
- Never operate heater unattended 6
- Never put anything on or cover radiation disk and protector at any time 6
- Never repeat the switching on and off sequence more than 3 times in case of problems consult with your distributor 6
- Never use heater in the presence of flammable or volatile gas such as spray cans 6
- Never use the heater in an altitude higher than 1 000m 3 000ft above sea level 6
- Pet 51001 203 032 6
- Read owner s manual before using 6
- Stop fire start fire 6
- Turn operation switch on combustion will start in about 15 seconds if the heater fails to ignite turn switch off and on again turn operation switch off combustion stops the operation lamp and blower remain on for 5 minutes after turning the switch off and then stop automatically 6
- Use only in places free of flammable vapors and excessive dust such as found in chips and waste paper 6
- Location of safety labels 7
- Safety information 8
- Safety information 9
- Safety information 10
- Safety information 11
- Safety information 12
- Gas requirement 13
- Heater specifications 13
- Specifications 13
- Wiring diagram 13
- Burner section switch section 14
- Main components 14
- Gas cylinder installation 15
- Hose connection 15
- Operation 15
- Safety devices 15
- Adjusting the 2nd pressure for solenoid valve 16
- Check leakage 16
- Do not touch or adjust a brass pipe on solenoid valve this is intended for maintenance person to check the manifold pressure if it is made any adjustment improperly gas leakage may occur 16
- Failure to adjust the 2nd pressure for solenoid valve causes incomplete combustion during operation thereby triggering the safety device to stop combustion 16
- Operation 16
- Operation 17
- Gas cylinder numbers for operation 18
- Operation 18
- Adjust the angle of main unit 19
- Connecting the power supply 19
- Do not use an adapter to change the power plug or power outlet from grounded 3 prongs or inlets to ungrounded 2 prongs or inlets as this improperly overrides the safety function in grounding the heater by means of the provided power plug also if the power cord or plug needs to be replaced replace only with genuine or shizuoka seiki approved replacement parts 19
- Extension cord size requirement 19
- Operation 19
- To avoid major burn injury be sure to take hold of the burner grip when setting the angle of the 19
- To avoid severe burns and electrical shock do not adjust the angle of the main unit while the heater is plugged in operating or hot 19
- After operation has stopped make sure that the flame is completely extinguished before leaving the heater unattended or moving or storing it 20
- If you detect smoke or a burning smell coming from the heater turn the heater off immediately to prevent a fire and contact your dealer to have the heater inspected prior to further operation if the heater does not ignite the first time do not try to ignite more than 2 more times in a row thereafter as this could result in a fire if the heater does not ignite after the third attempt make no further attempts and consult your dealer prior to further operation of the heater when using the heater be careful that the floor surface in front of it does not become overheated 20
- Ignition 20
- Operation 20
- Operation procedures 20
- Shut off 20
- Connecting the control device thermostat 21
- Heat shielding mat 21
- Maintenance 21
- Operation 21
- Operation with portable generator 21
- Filter replacement 22
- Maintenance 22
- If the heater is stored or not used for an extended period of time shut off the main valve for natural propane gas and disconnect the gas hose 23
- Storage 23
- Trouble recovery 23
- A c230v ac12v primary secondary 1ma 200ma 24
- Ac120v 24
- Ac230v 50hz 24
- Air switch 24
- Burner control p w b 24
- Circulation fan motor 24
- Combustion fan motor 24
- Gas valve 24
- Indicater display 24
- Neutral 24
- Power source live 24
- Protect earth 24
- Run switch run switch external thermostat external thermostat tip over high limit 24
- Schematic diagram for val6 gn5 gp5 24
- Secondary circuit 24
- Transformer 24
Похожие устройства
- Panasonic HDC-SD10EEK Black Инструкция по эксплуатации
- Panasonic DMC-FS12EE-K Black Инструкция по эксплуатации
- Caiman CP-205ST Инструкция по эксплуатации
- Caiman BH23K Инструкция по эксплуатации
- Panasonic TH-R50 PV8KHA Инструкция по эксплуатации
- Panasonic TH-R50 PV8KH Инструкция по эксплуатации
- Caiman CP-305ST Инструкция двигателя
- Caiman CP-305ST Инструкция по эксплуатации
- Panasonic TH-R37 PV8KA Инструкция по эксплуатации
- Caiman SM 800PRO Инструкция двигателя
- Caiman SM 800PRO Инструкция по эксплуатации
- Panasonic DMC-FS42EE-K Black Инструкция по эксплуатации
- Caiman SM 1000 Инструкция двигателя
- Caiman SM 1000 Инструкция по эксплуатации
- Panasonic DMC-FS7EE-K Black Инструкция по эксплуатации
- Panasonic DMC-FS62EE-K Black Инструкция по эксплуатации
- Caiman OH01 Инструкция по эксплуатации
- Panasonic SDR-SW21EE-D Orange Инструкция по эксплуатации
- Caiman SM 1000W Инструкция двигателя
- Caiman SM 1000W Инструкция по эксплуатации