Kramer SPK-C611 [11/16] Installing the open back ceiling speakers

SPK-C611 - Installing the Open-back Ceiling Speakers 7

Do not nail or staple the speaker wires.

If you are mounting the speakers onto a ceiling tile, remove the ceiling tiles where

you plan to install the speakers. Use the template to trace and then cutout the

speaker hole over an empty box.

The open-back ceiling speakers are supported by the ceiling mounting kit (two

C-rings and two pairs of tile rails. The tile rails prevent the speakers from falling if

the tile itself comes out or falls apart, as their ends catch onto the T-grid). When

mounting onto the ceiling tiles, use both supports.

Be sure that the tiles can support the speaker. Smaller sized tiles or

fiberglass-type tiles cannot support the weight of the speakers.

When this is the case, the speakers will need additional support.

When mounting onto a sheetrock ceiling, the C-ring alone is used to reinforce the

ceiling material.

5.3 Installing the Open Back Ceiling Speakers

To install the Open-back Ceiling speakers, do the following:

1. Remove the grille over the speakers by inserting a paper clip into one of the

grille openings and pulling it upward.

2. Position the mounting tabs (see

Figure 3) inward.

Figure 3: Position Mounting Tab

3. Insert the supplied screws into the screw openings from the front of the

speakers.