Kramer SPK-C611 [12/16] Using the suspended ceiling speaker mounting kit optional

8 SPK-C611 - Installing the Open-back Ceiling Speakers

4. Connect the speaker wires to the speaker terminals.

5. Insert the speaker into the opening and tighten the screws.

When tightening the screws, the tabs automatically turn outward, thus

clamping the speaker to the wall from its rear side.

Do not over-tighten the screws. It may cause damage to both the

speakers and the surface.

6. Push the grille firmly into the slot in the speaker baffle.

5.3.1 Using the Suspended Ceiling Speaker Mounting Kit (Optional)

To install the Open-back ceiling speakers using the mounting kit, do the following:

1. Place the C-ring over the hole cut in the ceiling tile (on the “ceiling” side).

Place it around the hole so that the tabs are located in parallel to the tile

edges (see

Figure 4).

Figure 4: Installing the Open-back Ceiling Speakers

2. Place the tile rails on the tile and snap them into the two tabs on the C-ring.

Align the rails so that the ends extend over the T-channel grid.

3. Insert a screw through each tab on the C-ring to secure the rails.

4. Connect the speaker wires to the speaker terminals.

T-channel Grid

Support Ring

Screws

Ceiling Tile

Tile Rails

C-ring