Makita hm1213c [7/40] Accessories
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Makita hm1213c [7/40] Accessories

Makita hm1213c [7/40] Accessories
7
MAINTENANCE
CAUTION:
• Always be sure that the tool is switched off and
unplugged before attempting to perform inspection
or maintenance.
Lubrication
CAUTION:
• This servicing should be performed by Makita
Authorized or Factory Service Centers only.
This tool requires no hourly or daily lubrication because
it has a grease-packed lubrication system. However, it is
recommended to periodically replace the grease for
longer tool life.
Run the tool for several minutes to warm it up. Switch off
and unplug the tool.
Loosen the six screws and remove the handle. Note that
the top screws are different from other screws.
Fig.12
Disconnect the connector by pulling them.
Fig.13
Loosen the four screws on crank cap and remove the
crank cap cover.
Fig.14
Wipe out the old grease inside and replace with a fresh
grease (60 g). Use only Makita genuine hammer grease
(optional accessory). Filling with more than the specified
amount of grease (approx. 60 g) can cause faulty
hammering action or tool failure. Fill only with the
specified amount of grease.
Fig.15
CAUTION:
• Be careful not to damage the connector or lead
wires especially when wiping out the old grease.
To reassemble the tool, follow the disassembling
procedure in reverse.
CAUTION:
• Do not tighten the crank cap excessively. It is made
of resin and is subject to breakage.
Fig.16
Connect the connector firmly and then reinstall the
handle.
CAUTION:
• Be careful not to damage the connector or lead
wires especially when installing the handle.
To maintain product SAFETY and RELIABILITY, repairs,
carbon brush inspection and replacement, any other
maintenance or adjustment should be performed by
Makita Authorized Service Centers, always using Makita
replacement parts.
ACCESSORIES
CAUTION:
• These accessories or attachments are
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
• Bull point(SDS-max)
• Cold chisel(SDS-max)
• Scaling chisel(SDS-max)
• Clay spade(SDS-max)
• Bit grease
• Safety goggles
• Hammer grease
• Plastic carrying case

Содержание

Похожие устройства

Скачать