Smeg WMF147X [19/22] Cleaning the detergent drawer

3. Pull out the drain hose “A”.

Attention: if the hose is hot it means the water is hot or boiling. Place a

tray on the floor and remove the plug “B” to drain the water.

Depending on the quantity of water, it may be necessary to empty the

tray several times.

When no more water comes out, push the hose back in and screw

back the plug “B”.

4. Unscrew the screw “G” with a screwdriver and remove the metal plate “F” which prevents the pump

cover “D” from turning.

Unscrew the pump cover “D” by turning it anti-clockwise.

Clean the pump body and remove any foreign bodies.

Check the inside “E” and make sure the impeller turns freely. If there are any foreign bodies, remove

them.

5. Then screw the pump cover back on.

Position the metal plate “F” so that it prevents the cover from

turning and tighten screw “G” with a screwdriver.

Fix the drain hose by snapping the plug into place «C».

Insert the lower part of the base plate first and then push it to-

wards the unit until it clicks into place.

5.5 CLEANING THE DETERGENT DRAWER

The detergent drawer should be kept clean, removing all solid deposits.

To simplify this operation, completely remove the detergent drawer (pull the

drawer fully out, press in the zone marked PUSH and then remove com-

pletely).

Remove the siphon "A" and clean all parts with hot water.

Fully re-insert the siphon and remove any detergent deposits before putting

the drawer back in position.

5.6 CLEANING THE WATER INTAKE FILTERS

The machine is fitted with a filter which protects the water intake valves.

The filter is in the fitting on the intake hose which is connected to the tap

The filter must be cleaned if the washing machine is not taking in water or the amount of

water is insufficient.

To clean, proceed as follows:

• Remove the mains plug to disconnect the appliance from the electricity

supply.

• Turn off the water tap.

• Unscrew the intake hose fitting from the tap.

• Clean the filter with water, with the aid of a small brush.

• When screwing the intake hose fitting back into place, check that the filter is positioned correctly.