Smeg WMF147X [5/22] The manufacturer declines all responsibility for injury or damage caused by failure to comply with the above regulations or deriving from tampering with even just one part of the a...

For Great Britain only

Warning: this appliance must be earthed.

Fuse replacement

If the mains lead of this appliance is fitted with a

BS 1363A 13amp fused plug, to change a fuse in

this type of plug use an A.S.T.A. approved fuse to

BS 1362 type and proceed as follows:

1. Remove the fuse cover (A) and fuse (B)

2. Fit replacement 13A fuse into fuse cover

3. Refit both into plug

Important:

The fuse cover must be refitted when changing a

fuse and if the fuse cover is lost the plug must not

be used until a correct replacement is fitted.

Correct replacement are identified by the colour

insert or the colour embossed in words on the

base of the plug.

Replacement fuse covers are available from your

local electrical store.

If the appliance is provided with a plugless supply cord:

• It is necessary to install in the fixed wiring an all-pole disconnection device having a gap be-

tween contacts of at least 3,5mm. After installation the disconnection device has to be easy to

reach.

• The connection to the mains must be carried out by a qualified technician in accordance to the

scheme shown below and the regulations in force

= brown

= blue

= yellow-green

• In the event of damage to the supply cord, it has to be replaced by the manufacturer or an au-

thorized technical service center in order to avoid any risk.

Important!

This appliance is easy to use.

However, for the best results it is important to read this manual carefully and follow all the instructions

before putting it into operation.

The manual provides the correct instructions for installation, use and maintenance, as well as giving

useful advice.

The manufacturer declines all responsibility for injury or damage caused by failure to

comply with the above regulations or deriving from tampering with even just one part of the

appliance and the use of non-original spare parts.