Rommelsbacher ct 2203/tc [22/24] Cleaning and maintenance

22

Error code

The electronic control features many internal monitoring functions. Thus, there is an automatic self-

adjustment of the sensors to the ambient conditions also in off mode.

The glass surface above the sensors must never been covered.

Attention: Atextremeextraneouslight,darkeningorifthesensorsarecoveredwithalight

object, an adjustment is not possible. The display shows the error code “F” and a signal tone

is audible. The power supply is cut or the control is switched off. As long as there is an error,

the unit can not be switched on again.

• Removeanycoarseresiduesfromtheglassceramicplatebymeansofaspecialglassscraper,whichis

available in the specialised trade and in household equipment shops.

• Followingthatcleanthecoldglasssurfacewithadampclothandsomedishwaterandwipeitdrywitha

clean cloth or kitchen tissue. On the market there are suitable cleaning agents for glass ceramic cooktops

available with which the whole glass surface is treated by means of a kitchen tissue until there is no

soiling visible anymore.

• Wipethestainlesssteelcasingwithadampclothandwipeitdry.Specialcleaningagentsandcare

products for stainless steel surfaces are also available on the market.

• Neverimmersetheapplianceintowateranddonotusesteamjetappliances.

• Makesurenowaterorsteammayinltratetheappliancefrombeloweither.