Syma x11c [8/12] Battery repair maintenance
![Syma x11c [8/12] Battery repair maintenance](/views2/1190622/page8/bg8.png)
-7-
Caution:
1.When using the computer for charging,
please remember to pull out the
charging line before shutting down
the computer.
2.Please pay attention to aim correctly
to the correct polarity when connecting
the USB wire with the battery.Please make
sure the polarityshould not be upside down.
Charging time: about 70 minutes ;Flying time: about 5 minutes
CAUTIONS WHEN CHARGING
1.When charging,please put this product on the dried or ventilated area and
keep it far away from heat source or explosive product.
2.When charging, please remove the batteries from the quad copter.All the
charging process should be under the guidance of the adult so as not to
cause accident.
3.When finish flying, please do not charge the battery which surface
temperature is still not cooled down.Otherwise it may cause swollen battery
or even cause fire disaster.
4.During the process of battery charging, falling down or striking by the outer
force should be avoided.Otherwise it may cause short-circuited within the
battery and thus may cause danger.
5.In order to make sure safety, please make sure that you need to use the
original USB charging wire that made from our factory. When the battery is
used for a long time or appears aging or swollen,please replace them timely.
6.When the batteries are fully charged, if you do not remove it from the charger
for a long time, the battery may discharge automatically, which may cause
battery exhaustion. When the battery voltage that the charger has tested is
lower than the rated voltage, the charger will re-charge the battery until it is
fully charged. Charging or discharging too often or repeated charging or
discharging may reduce the using life of the batteries.
1. Battery should be put in the dried or ventilated place with environment
temperature about 18-25 ℃.
2.In order to enhance the using life of the battery, please avoid repeat charging
or excessive discharging.
3.When the battery needs to be stored for a long time, please charge the
battery first.That is to say, charge the battery for about 50-60% of the volume
and then well store it.
4.If you do not use it for more than 1 months, it’s highly recommended that you
need to check the battery voltage every month so as to make sure the voltage
no less than 3V. Otherwise please do by following No.(3) mentioned.
BATTERY REPAIR & MAINTENANCE
Содержание
- Implement standard gb t26701 2011 1
- Instruction manual 1
- Four axis structure is applied which makes the quadcopter more flexible and rapid when flying it has the characteristics of wind resistant and can be flied indoor or outdoor 2
- Important instruction 2
- Preface 2
- Safty cautions 2
- About contents 3
- Introduction of transmitter remote control installing the battery 3
- Ready to fly your quad copter 3
- Cautions 4
- Functions mode switch fine tuning reset and level calibration 4
- Fine tuning operation 5
- Illustration on controlling the quad copter mode 1 defaulted mode when starting 5
- Operating direction 5
- Pull the throttle left or right the quadcopter turns to left or right 5
- Fine tuning operation 6
- Illustration on how to control the quad copter mode 2 6
- Operating direction 6
- Pull the throttle left or right the quadcopter turns to left or right 6
- Battery charging 7
- D eversion and throwing flight instructions 7
- Flight control 7
- Battery repair maintenance 8
- Cautions when charging 8
- Get to know take photo and video ① turn on the transmitter and pull left lever up and down to connect signal between quodcopter and transmitter ② take photo make sure camera normally work when push the button c up camera will take a photo after a beep from transmitter and the green indicator on camera will be red and flash on time take video make sure camera normally work when pull the button c down camera starts to take video after a beep from transmitter and the green indicator on camera will change to red than keep flashing press the button c slightly again another beep from transmitter means video stopped and the red flashing light on camera will be green and keep light on 9
- Trouble shooting 9
- Blades motor a gear 11
- Motor b battery circuit board 11
- Transmitter reader camera pcb box 11
- X11c 03 x11c 04 x11c 06 x11c 05 11
- X11c 07 11
- X11c 08 x11c 09 11
- X11c 10 11
- X11c 11 11
- X11c 12 11
- X11c 13 11
- V 200mah 12
- X15 coreless motor 12
Похожие устройства
- Syma x5sc Инструкция по эксплуатации
- Syma f3 Инструкция по эксплуатации
- Sven standard 303 black usb Инструкция по эксплуатации
- Sven standard 303 Инструкция по эксплуатации
- Sven ic-310 Инструкция по эксплуатации
- Sven ic-300 Инструкция по эксплуатации
- Sven ht-435r Инструкция по эксплуатации
- Sven ihoo mt-5.1p Инструкция по эксплуатации
- Sven avr-2000 lcd Инструкция по эксплуатации
- Sven btr5-10 Инструкция по эксплуатации
- Sven ic-950 hd Инструкция по эксплуатации
- Sven ic-350 Инструкция по эксплуатации
- Sven special base black Инструкция по эксплуатации
- Sven optima pro Инструкция по эксплуатации
- Sven Comfort 7600 EL Инструкция по эксплуатации
- Sven Comfort 7200 EL Инструкция по эксплуатации
- Sven comfort 3050 white usb Инструкция по эксплуатации
- Sven Challenge 9700 Инструкция по эксплуатации
- Sven ap-b350mv bluetooth Инструкция по эксплуатации
- Sven SEB-B270MV Инструкция по эксплуатации
Скачать
Случайные обсуждения