Moxa IMC-21A-S-SC [5/12] Grounding the moxa imc
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Moxa IMC-21A-S-SC [5/12] Grounding the moxa imc

Moxa IMC-21GA-LX-SC [5/12] Grounding the moxa imc
- 5 -
• Use separate paths to route wiring for power and devices. If power
wiring and device wiring paths must cross, make sure the wires are
perpendicular at the intersection point.
• Do not run signal or communications wiring and power wiring in the
same wire conduit. To avoid interference, wires with different signal
characteristics should be routed separately.
• You can use the type of signal transmitted through a wire to
determine which wires should be kept separate. The rule of thumb is
that wiring that shares similar electrical characteristics can be
bundled together.
• Keep input wiring and output wiring separated.
• We strongly advise that you label wiring to all devices in the system.
Grounding the Moxa IMC
Grounding and wire routing help limit the effects
of no
ise due to electromagnetic interference
(EMI). Run the ground connection from the
right
most connector of the 3-contact terminal
block to the grounding surface
before
connecting
the
devices.
ATTENTION
This product is
intended to be mounted to a well-grounded
mounting surface such as a metal panel.
Wiring the Power Inputs
The two leftmost contacts of the 3-contact terminal block connector on
the IMC’s top panel are used for the IMC’s DC inputs. Take the following
steps to wire the IMC’s DC power inputs:
STEP 1: Insert the negative/positive DC wires
into the V
-/V+ terminals.
STEP 2: To keep the DC wires from pulling loose,
use a small flat
-
blade screwdriver to tighten the
wire
-clamp screws on the front of the terminal
block connector.
STEP 3:
Insert the plastic terminal block
connector prongs into the terminal block
receptor, which is located on IMC’s top panel.

Содержание

Похожие устройства

Скачать