Moxa EXPC-1319-STS-FX-W7E [16/49] Expc 1319 series hardware hardware installation

EXPC-1319 Series Hardware Hardware Installation

2-5

VESA Mounting

The EXPC-1319 comes with two sets of holes reserved for VESA mounts (FDMI): VESA 100 and VESA 75. Refer

to the following figures for the specific locations of the VESA mounting screw holes.

NOTE

To make sure the panel computer will be s

ecurely installed on a wall, we suggest you to use the screws

with the

specifications of

M4. The screw holes penetrate 6 mm into the computer’s case. When choosing screws for

installation, remember to account for the thickness of the mounting surface.

Refer to

Appendix B: Statement

of Regulatory Approval

for the technical details regarding regulation Class 1 Div. 2 devices.

Wiring Requirements

The following common safety precautions should be observed before installing any electronic device:

• Strive to use separate, non-intersecting paths to route power and networking wires. If power wiring and

device wiring paths must cross, make sure the wires are perpendicular at the intersection point.

• Keep the wires separated according to interface. The rule of thumb is that wiring that shares similar

electrical characteristics may be bundled together.