Moxa EXPC-1319-STS-FX-W7E [18/49] Db 15 female vga connector

EXPC-1319 Series Hardware Hardware Installation

2-7

Connecting to a Display

The EXPC-1319 comes with a 19-inch LED-backlit LCD display. Because the configuration of a 2

or alternate

display may be required, the EXPC-1319 also comes with a VGA interface on its bottom panel. The VGA

hardware interface is a standard D-Sub 15-pin female connector; to ensure that the monitor image remains

clear, be sure to tighten the monitor cable after connecting it to the EXPC-1319 computer. The pin assignments

are shown below.

WARNING

When the

external VGA display is not in use, make sure that the protective cap and the tether tail have

been

securely fasten

ed so that the waterproof function can work well. Please note that when reinstalling the

protective cap

, it must be fully tightened to insure the unit is sealed correctly to meet the IP66 enclosure

rating.

You may refer to Appendix B: Statement of Regulatory Approval for the technical details

regarding

regulation Class 1 Div. 2 devices

DB-15 Female VGA Connector

Pin No. Signal Definition Pin No. Signal Definition

Red

VCC

2 Green 10 GND

3 Blue 11 NC

4 NC 12 DDC2B Data

5 GND 13 HSYNC

6 GND 14 VSYNC

7 GND 15 DDC2B Clock

8 GND

Connecting USB Devices

The EXPC-1319 embedded computer has two USB 2.0 ports on the bottom panel. All of the ports are UHCI, Rev

2.0 compliant and support Plug & Play and hot swapping. These ports can be used to connect USB devices such

as a keyboard, mouse, USB flash disk, and USB CD-ROM. In addition, both USB ports support system boot up,

which can be activated by modifying the BIOS settings. BIOS configuration is described in detail in

Chapter 4:

BIOS Setup. Follow the steps below to wire up the USB connectors.