Moxa MD-124X [12/33] Installing the md 124

MD-124 HW Manual Hardware Installation and Peripherals

3-2

Installing the MD-124

Installing the Rubber Waterproofing Cushion

The MD-124 comes with a rubber waterproofing cushion that helps protect the displays when installed on a wall,

or in a cabinet. Gently turn back the MD-124, and place the cushion on four sides of the display.

Cabinet Mounting

The MD-124 comes with a console mounting kit that helps users mount the display into a cabinet. There are

nine sets of console mounting holes on four sides of the MD-124. Each mounting point has two

standards-compliant locations for screws to go into, depending on the thickness of the wall or cabinet. Simply

fasten the screws to the mounts in the correct place.

For safety reasons, it is important to ensure that all four corners and sides of the panel are firmly attached to

the cabinet, so that the display and cabinet assembly is stabilized.

ATTENTION

Clean the monitor using a soft material such as a microfiber cloth. You may also use LCD cleaning liquid to

clean the monitor.

Avoid using coarse or rough mat

erial to clean the monitor as this may damage the optical bonding.

Wiring Requirements

This section describes how to connect serial devices to the display.

You should read and follow these common safety precautions before proceeding with the installation of any

electronic device:

• Use separate paths to route wiring for power and devices. If power wiring and device wiring paths must

cross, make sure to cut interference problems by keeping the wires perpendicular at the intersection points