Lumme LU-2508 [9/25] Blades alignment

9

 Set № 3 (9 mm) or № 4 (12 mm) comb and continue to cut hair to the top of the head (fig. 3).

STEP 4 – TOP OF THE HEAD

 Set № 3 (9 mm) or № 4 (12 mm) comb and start to cut top of the head from back to front along the direction of normal hair growth (fig. 4).

 Comb attachment № 1 (3mm) or № 2 (6mm) are used to achieve a close crew cut or short cut.

 For longer haircut on the top of the head use the flat comb and lift hair on the top of the head. Cut over the comb, with the hair lifted or hold the hair between the fingers to lift it and cut it to desired

length (fig. 5-6). Always start from the back of the head. You can cut the hair shorter gradually by reducing the space between the comb/fingers, and the head. Comb out trimmed hair and check for

STEP 5 – FINAL HAIR LEVELING

 Finally, use the lowest blade adjustment level. You don‟t need any comb. Trim hair around the base of the neck,

sides of the neck and the ears with the clipper.

 Reverse the hair clipper (fig. 7).

 Press the clipper right angles to the head, tips of the blades lightly touching the skin and work downwards.

SHORT HAIRCUTS AND FLAT TOPS

 Blades must be realigned if they have been removed for cleaning or replacement.

 To realign the blades simply match the upper and bottom blades teeth up, point for point.

 End of top blade teeth should be approximately 1.2 mm back from bottom blade. Compare your clipper blades with the figure.

 If blades are set incorrectly, add few drops of oil to the blades, switch on the clipper for a few seconds, then switch it off and unplug.

 Loosen screws slightly and adjust the blades. Tighten screws after blade is aligned.

 If the hair clipper buzzes, then adjust it using the screws (on the device). Before adjusting oil the blades.

CLEANING

 Mind to clean the appliance regularly for appliance and blades long life.

 Ensure that the appliance is switched off.

 Remove cut hair from the blades with the brush.