GBC SureBind System 1 [4/6] Operating instructions

4.0 OPERATING INSTRUCTIONS

4.1 Punching

1. Adjust the punch edge guide to the correct paper length. Check the punch

alignment by punching a sheet of paper and folding it in half along the punched

edge (See Figure 4-1). Match the holes up: if the corners of the paper match

with no overlap, the alignment is correct. If not, readjust the guide and repeat

the process until the edges are square.

2. Place the paper fully in the punch throat and slide the paper to the left against

the punch edge guide. Lower the handle with a firm, even motion. Raise the

handle and remove the paper.

3. To prevent jamming, only 25 sheets of 20 pound bond paper should be punched

at one time (fewer sheets if the paper is heavier). Do not punch more than 4

composition covers or 3 plastic covers at one time.

Figure 4-1

4-1