Home
Главная
Vitek
Кофеварка
VT-1524 GD
Инструкция по эксплуатации Страница: 5

Vitek VT-1524 GD [5/36] English

E N G L I S H

ter holder (5). At this time the unit is cleaning

and heating up.

Washing of the filter and the cappuccinator

pipe is finished.

MAKING ESPRESSO

• Make sure that there is enough water in the

water tank (13) and the steam supply han-

dle (14) is set to the utmost right position and

slightly tightened.

• Remove the filter holder (5) from the coffee

maker boiler by turning the filter holder handle

(3) clockwise in the direction of the inscription

«INSERT».

• Put ground coffee in the selected filter (6)

(depending on how many coffee cups you

want to make) and slightly tamp it with the

back side of the measuring spoon (18). Insert

the selected coffee filter (6) into the filter

holder (5), matching the ledge on the filter (6)

with the slot on the filter holder (5) and turn

the filter (6) in any direction.

• Attach the filter holder (5) to the coffee maker

boiler; to do this, place the filter holder han-

dle (3) under the inscription «INSERT» on the

coffee maker body, insert the holder (5) into

the boiler and turn the filter holder handle (3)

counterclockwise as far as it will go (in the

direction of the «LOCK» mark).

• Press the button (7) or (8) depending on how

many cups of coffee you want to make, the

corresponding indicator will light up. Water

will start pouring from the outlet openings of

the filter holder (5). Watch the cup being filled

with ready coffee.

• After you remove the cup with the coffee,

some water may drip from the filter holder

(5) openings on the tray grid (2). It is normal.

Control the tray (1) filling, periodically pour

out the liquid from it and wash the tray (1)

with water.

• Wait until the coffee maker cools down and

remove the filter holder (5).

• To remove the filter holder (5), turn the fil-

ter holder handle (3) in the direction of the

inscription «INSERT» on the coffee maker

body and remove the holder (5).

• Lift the filter clamp (4) and press it to the

holder (5), holding the filter (6) with it, turn the

holder (5) upside down and remove ground

coffee remnants.

• Remove the filter (6) from the holder (5) and

wash the filter (if you cannot remove the filter,

turn it in any direction until the ledge on the

filter (6) matches the slot in the holder (5)).

HOW TO MAKE A GOOD ESPRESSO

• Use fresh ground coffee for “espresso” cof-

fee makers.

• Slightly tamp the ground coffee in the filter

(6), you can do it with the back side of the

measuring spoon (18).

• Coffee strength depends on the quality and

grinding degree of coffee beans and on the

water supply time.

• If coffee is pouring out too long, this means

the coffee powder is too fine or it is tamped

too strongly.

MAKING CAPPUCCINO

Make coffee, as described in the section

«MAKING ESPRESSO», in a cup with enough

capacity to add frothed milk or cream.

Attention! When switching the steam supply on,

be careful to avoid burns by hot water drops and

hot steam.

• Make sure that there is enough water in the

water tank (13), the steam supply is off and

the steam supply handle (14) is set to the

utmost right position and slightly tightened.

• Press the button (10) and wait until the cof-

fee maker boiler heats up. During heating

the button (10) indicator will be flashing;

after heating is over the indicator will light

constantly.

• Take a narrow high tumbler (preferably a

metal one), and fill it with cold milk or cream

approximately by 1/3 (about 100 g milk per

each serving).

Note: The tumbler diameter should be at least

70-75 mm. When choosing a tumbler take into

account that during frothing the amount of milk

can double.

• Take the cappuccinator handle (16), draw the

cappuccinator pipe tip (17) into the tumbler,

immersing it into milk by approximately 2 cm.

The cappuccinator pipe tip (17) should not

touch the bottom of the tumbler, as this can

prevent the steam release.

• Switch the steam supply on and slowly turn

the handle (14) counterclockwise, steam will

start going out from the cappuccinator pipe

tip (17). For best results set the steam release

intensity at your discretion.

Note: Do not turn the handle (14) fast to avoid

burns by hot water drops and hot steam.

IM VT-1524.indd 5 29.06.2016 17:37:38

Vitek VT-1524 GD [5/36] English

Содержание

Похожие устройства