Home
Главная
Gross
Пневматическая Трещотка
g120
Инструкция по эксплуатации Страница: 11

Gross g120 [11/20] Maintenance

Содержание

Похожие устройства

to the inlet opening before connecting the hose To lubricate the tool apply air tool oils with ISO VG 32 vis cosity and an automatic air line lubricator adjusted to sup ply 2 droplets per minute If the use of an automatic air line is not possible apply 4 5 droplets of air tool oil to the inlet pipe opening before each use of the tool Using of oil with higher viscosity may deteriorate performance Always connect the air supply hose to the tool at first and then connect it to the air preparation unit Install the drive socket on the square connection Check the set direction of rota tion To screw screws and nuts set the switch in the F direction of rotation Forward To unscrew screws and nuts set the switch in the R direction of rotation Reverse Check the position of the torque regulator when unscrewing the maximum torque is used when screwing the torque should meet the type size and durability of the threaded joint NOTE The rotation control switch may only be used when the tool is turned off CAUTION Impact drive sockets may only be used NOTE Use only the tool intended for the operation with impact loads Do not use coupling arrangements To turn on the tool press the switch and hold it pressed when performing a work operation To turn off the tool release the switch NOTE Disconnect the air supply hose from the tool before changing its accessories or adjusting it Place the tool on screws bolts or nuts only when the tool is turned off Rotating parts can slide off the tool MAINTENANCE Disconnect the air supply hose from the tool before changing its accessories or adjusting it Regularly clean the mesh filter at the air inlet For this purpose unscrew the branch pipe connecting the hose and remove dust and dirty from the filter After that install the branch pipe con necting the hose and fix it securely To prevent corrosion which is a reason of deterioration of vanes valves etc it is necessary to drip some droplets of ISO VG32 motor oil connect the tool to an air line and turn on the tool at idle speed for 5 10 seconds In case of long downtime or before the first switching on always perform this procedure After the work always clean the tool of dirty Do not use any sub stances containing chlorine gasoline or solvents After cleaning it wipe the tool with a dry cloth Motor vanes should be checked on a regular basis by specialists and changed if necessary The scheduled maintenance of the tool should be performed at least once per 6 months All tool repair operations should be performed by qualified spe cialists of service centres with the use of original spare parts TRANSPORTATION Transportation can be performed in all types of enclosed trans port in accordance with the transportation rules valid for each

Скачать