Home
Главная
Candy
Стиральные Машины
CS 2108
Инструкция по эксплуатации Страница: 37

Candy CS 2108 [37/39] Chapter 13 faults search

CHAPTER 13 FAULTS SEARCH

FAULT CAUSE REMEDY

Mains plug not plugged in Insert plug1. Does not function on any

program

Mains switch not on Turn on mains switch

No power Check

Electric circuit fuses failure Check

Load door open Close load door

See cause 1 Check2. Does not load water

Inlet tap turned off Turn on water inlet tap

Timer not set correctly Set timer on correct position

Discharge tube bent Straighten discharge tube3. Does not discharge water

Odd material blocking filter Check filter

4. Water on floor around

washing machine

Leak from the washer between the tap

and inlet tube

Replace washer and tighten the

tube on the tap

The washing machine has not dis-

charged water

Wait a few minutes until the ma-

chine discharges water

5. Does not spin

"No spin" setting (some models only) Turn the programme dial onto spin

setting

6. Strong vibrations during

spin

Washing machine not perfectly level Adjust special feet

Transport bracket not removed Remove transport bracket

Washing load not evenly distributed Distribute the washing evenly

NOTE: The machine is fitted with a special electronic device, which prevents the spin cycle should

the load be unbalanced. This reduces the noise and vibration in the machine and so prolongs the life

of your machine.

If the fault should persist, contact a Candy Technical Assistance Centre. For prompt servicing, give the model

of the washing machine, to be found on the label placed on the cabinet inside of the porthole or on the guaran-

tee certificate.

WARNING!

1 The use of environment friendly detersives without phosphates may produce the following ef-

fects:

· The discharge rinse water may result cloudier due to the presence of zeolites in suspension. This

does not compromise the efficiency of the rinses.

· The presence of white powder (zeolites) on the washing at the end of the washing cycle. This

does not remain incorporated in the fabric and does not alter the colour.

· The presence of foam in the last rinse water which is not necessarily a sign of inadequate rinsing.

· The non-ionic surface-active agents present in the composition of washing machine detersives

are often difficult to remove from the washing itself and, even in small quantities, may produce visi-

ble signs of the formation of foam.

· Carrying out further rinses, in cases such as this, is not useful.

2 If your washing machine fails to function, carry out the above-mentioned checks before calling the

Candy Technical Assistance Service.

Candy CS 2108 [37/39] Chapter 13 faults search

Содержание

Похожие устройства