Vitek VT-3539 [4/64] English

ENGLISH

READ BEFORE USING

For best results:

1. First install the battery in the remote sensor(s), and then in the receiver block.

2. Place the receiver and remote sensor(s) next to each other. This will synchronize the

receiver block with the remote sensor(s).

3. Place the remote sensor(s) at a proper operating distance.

• Although the remote sensor is designed to be weather-proof, it is recommended

that you install it in a location where it will not be exposed to direct sunlight, rain or

snow.

• Walls and the location of the remote sensor affect the effective operating range. Try

various installation locations and then choose the optimal one.

GETTING STARTED

Step 1: Setting up the remote sensor:

1. Remove the lid from the battery compart-

ment and, according to the proper polarity,

insert two AA batteries. Close the battery

compartment lid.

2. The indication HOUSE CODE will blink on

the display for 8 seconds.

3. Choose a HOUSE CODE (from 01 to 15) by

pressing the C/F button. Make sure that all

the sensors in your home are set to the same

HOUSE CODE.

4. Press SET to save the HOUSE CODE. The

channel indicator will blink on the display for

8 seconds.

5. Choose the CHANNEL (from 1 to 4) by

pressing the C/F button. This number can

be confirmed by either pressing SET or, au-

tomatically, by waiting 10 seconds without

pressing any buttons. If you are only using

one sensor, we recommend that you use

CHANNEL number 01.

35391.indd 435391.indd 4 23.05.2006 17:08:5123.05.2006 17:08:51