Vitek VT-3539 — настройка метеорологической станции: температура и влажность [5/64]

Превью страниц Страница 5 / 64

ENGLISH

6. The temperature and humidity readings will appear on the display.

7. Switch from °F to °C by pressing the C/F button.

After these remote sensor settings have been completed, it will begin to transmit

weather data once per minute.

• If your meteorological station registers signals from neighboring sources, choose a

different house code.

• Factory default settings: house code = 01, channel = 01

Step 2: Receiver settings

8. Remove the lid from the battery compartment and, ac-

cording to correct polarity, install two AA batteries. Close

the battery compartment lid.

SYNCHRONIZING THE OUTDOOR TEMPERATURE READING

Auto-detect function:

1. After installing batteries in the receiver, activate the auto-

detect function, which should take about 3 minutes.

2. During these 3 minutes, the receiver will emit an audible

signals and display it once received the data from sensors.

• If no signal is received during the 3 minutes, the outdoor

temperature will be displayed as “- - -”. If this happens,

try installing all of the units closer together, or in different

places; run the auto-detect function again – remove the

batteries from the receiver and then insert them again.

Manual learning function (Search for remote sensor signals):

If a new sensor is added or if the signal is lost from an existing sensor (the outdoor tem-

perature on the display will blink), the detection function must be completed again.

35391.indd 535391.indd 5 23.05.2006 17:08:5123.05.2006 17:08:51