Smeg CW511MDA-2 [14/24] Starting the peristaltic pumps in manual mode rapid filling of detergent and rinse aid circuit

CW/CWH 511

6.6 Starting the peristaltic pumps in manual mode – rapid filling of detergent and rinse

aid circuit

With the dishwasher powered up and the tank full, press the buttons simultaneously for 5”

The peristaltic pumps continue to operate until one of the 2 buttons is pressed again; the lights remain on as long as the pumps

are running. The display shows “r d” . Bear in mind that the rinse aid peristaltic pump fills the circuit in about 7 minutes, while

for the detergent it only takes 2 minutes. So draw only rinse aid from the jerry cans (1 for the rinse aid and the other for the

detergent) for the first 5 minutes and then also take in detergent for the last 2.

6.7 Adjusting the regeneration frequency (models with softener only)

See appliance setup menu (point 6.4)

With values over 60°dF an external water treatment device must be used and the regeneration frequency must

be set at H0

6.8 Mains water hardness setting table

This table shows the relationship between the intake water hardness and the quantity the resins are able to treat;

regeneration is required once the appliance has performed the set number of cycles. Regeneration cycle duration: 12

minutes.

Hardness

(°dH German degrees)

Hardness

(°dF French degrees)

Setting

level

Resin regeneration interval:

approximate number

of wash cycles

Regeneration off Regeneration off

8.5 15

H1 81

11 20

H2 69

17 30

H3 default 42

22.5 40

H4 24

28 50

H5 19

33.5 60

H6 11