Animo WKI 20N 3KW SEA [11/14] Cleaning daily
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Animo WKI 20N 3KW SEA [11/14] Cleaning daily

Animo WKI 20N 6KW [11/14] Cleaning daily
16
06/2008WKI n
6.2 Brewing tea
A tea filter with disk and a filling pipe is needed to
brew tea in a container (optional) in combination with
WKI.
Fig. 8
A - Filling pipe
B - Tea filter with disk
C - Blender / transport disk
D - Container and lid
1. The inner pot of the container must always be
fresh and clean.
2. To avoid temperature loss during the brewing
process we recommed you to pre heat the
container, by putting the cable into a power
socket. Filling the container with approx. 2
litres of hot water and switch on the container for
at least 10 minutes before the brew starts.
The indication lamp on the container will light up.
3. Put the tea, loose or in bags, in the tea filter,
approximately 6 grams per litre.
4. Insert the tea filter into the disk already placed in
the container.
5. Tap the water from the container.
Place the filling pipe on the tea filter and the disk.
Then position the swivel arm over the pipe.
A
B
D
C
Fig. 8
6. Fill the water boiler with the required quantity of
water and wait until the water has reached the
temperature set. Open the tap as far as possible,
allowing it to vent properly. Afterwards, the flow
can be reduced to a level that can be processed
by the water distributor on the filter. Adjust the
flow rate so that the container fills up in approx. 5
to 6 minutes.
7. Once the water level in the water boiler has
reached 0, the tap can be closed and the water
boiler can be refilled and heated for the next
brew.
8. Remove the pipe and the tea filter after
the tea has been made.
9. ATTENTION: After brewing put the lid on the
container to avoid loss of temperature and taste.
The optimum extraction time is minimally 4
minutes and maximally 15 minutes. After more
than 15 minutes the flavour of the tea
decreases.
10. Rinse the tea filter immediately after use.
Attention! Always place the blender / transport disk
and the lid when transporting the container (by hand
or serving trolley), this prevents spilling from the
container.
7. MAINTENANCE
• Cleaning (daily) See section 7.1
• Descaling See section 7.2
7.1 Cleaning (daily)
• Clean the outside of the appliance with a clean
damp cloth, if necessary using a mild (non-
abrasive) cleaning agent.
• Do not use an abrasive, as this will leave
scratches and dull spots.
WARNING
* Do not leave the unit during maintenance.
* Always follow the instructions, which are
supplied with the used scale remover.
* It is advisable to wear safety glasses and gloves
during descaling.
* After descaling, run the appliance through at
least three cycles.
* Wash your hands after descaling.
* Do not submerge or spray the unit.
* Have all repairs carried out by a qualified
technican.

Содержание

Похожие устройства

Скачать