ISA Alfa 130 RV TN Small [13/34] Installation

ALFA

USE AND MAINTENANCE MANUAL

428000487237

8. INSTALLATION

This manual supplies the information necessary for correct unpacking, procedures for

positioning and connection to mains electricity.

8.1 STORAGE and UNPACKING

The appliance, with or without the packaging, should be carefully stored inside warehouses or in areas

away from the elements and direct sunlight, at a temperature between 00 and +40 °C.

The appliance should only be moved by qualiﬁ ed personnel operating forklift trucks, the power of which

should be suited to handling the weight of the product: when performing this task,

the appliance MUST be placed on the special pallet supplied.

Unpack the appliance by removing the screws ﬁ xing it to the pallet.

All packaging materials are recyclable and should be disposed of in accordance with local regulations.

Please destroy "plastic" bags to prevent them from becoming hazardous to children (suffocation).

8.2 INSTALLATION - POSITIONING - ENVIRONMENTAL CONDITIONS

Attention

Suitable for installation in a dry, well ventilated room. There should be a good air ﬂ ow around the

compressor and condensing unit. Therefore the area around the unit should not be obstructed by

boxes or other objects.

Position the appliance away from heat sources (radiators, stoves of all types, etc.) and away from

the effects of continuous currents of air (e.g. caused by fans, air conditioning vents, etc.). If it is

unavoidable to install near a heat source, use a suitable insulating plate,

Also avoid exposure to direct sunlight; all of this causes the temperature inside the refrigerated

compartment to rise with negative consequences on operation and energy consumption. Do not use

the appliance outdoors and do not leave it exposed to rain.

8.3 ELECTRICAL CONNECTION

Attention

Check that the network voltage matches the one displayed on the identiﬁ cation plate of the

appliance, and that the required power is adequate.

Check on the socket that the power supply voltage provides rated voltage (±10%) when you start

up the compressor.

The plug should be directly connected to the electrical socket. It is forbidden to connect the plug to

the socket by means of multiple socket extensions or adaptors.

The plant power supply socket must be ﬁ tted with a disconnection device from the mains electricity

(dimensioned to the load and in compliance with Standards in force), which guarantees complete

disconnection in category III (3) over-voltage conditions and therefore protects the circuits against

earth faults, overloads and short circuits.

Do not route the electricity cable in passageways.

Attention

Earthing is necessary and mandatory by law.