Indesit KN 3E107A W [23/36] Care and maintenance

Indesit KN 3E107A W [23/36] Care and maintenance
GB
23
Respecting and conserving the
environment
You can help to reduce the peak load of the
electricity supply network companies by using the
oven in the hours between late afternoon and the
early hours of the morning.
Always keep the oven door closed when using the
GRILL and DOUBLE GRILL modes. This will
achieve better results while saving energy
(approximately 10%).
Check the door seals regularly and wipe them
clean to ensure they are free of debris so that
they adhere properly to the door, thus avoiding
heat dispersion.
Switching the appliance off
Disconnect your appliance from the electricity
supply before carrying out any work on it.
Cleaning the appliance
! Do not use abrasive or corrosive detergents such
as stain removers, anti-rust products, powder
detergents or sponges with abrasive surfaces: these
may scratch the surface beyond repair.
! Never use steam cleaners or pressure cleaners on
the appliance.
The stainless steel or enamel-coated external
parts and the rubber seals may be cleaned using
a sponge that has been soaked in lukewarm water
and neutral soap. Use specialised products for
the removal of stubborn stains. After cleaning,
rinse and dry thoroughly. Do not use abrasive
powders or corrosive substances.
The inside of the oven should ideally be cleaned
after each use, while it is still lukewarm. Use hot
water and detergent, then rinse well and dry with
a soft cloth. Do not use abrasive products.
Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product,
then dry thoroughly with a soft cloth. Do not use
rough abrasive material or sharp metal scrapers
as these could scratch the surface and cause the
glass to crack.
The accessories can be washed like everyday
crockery, and are even dishwasher safe.
Dirt and grease should be removed from the
control panel using a non-abrasive sponge or a
soft cloth.
Stainless steel can be marked by hard water that
has been left on the surface for a long time, or by
aggressive detergents containing phosphorus.
After cleaning, rinse well and dry thoroughly. Any
remaining drops of water should also be dried.
The cover
If the cooker is fitted with a cover, this
cover should be cleaned using
lukewarm water. Do not use abrasive
products.
It is possible to remove the cover in
order to make cleaning the area behind
the hob easier. Open the cover fully
and pull it upwards (
see figure
).
! Do not close the cover when the burners are alight or
when they are still hot.
Inspecting the oven seals
Check the door seals around the oven regularly. If
the seals are damaged, please contact your nearest
After-sales Service Centre. We recommend that the
oven is not used until the seals have been replaced.
Replacing the oven light bulb
1. After disconnecting the oven
from the electricity mains,
remove the glass lid covering
the lamp socket (
see figure
).
2. Remove the light bulb and
replace it with a similar one:
voltage 230 V, wattage 25 W,
cap E 14.
3. Replace the lid and reconnect
the oven to the electricity supply.
Assistance
Please have the following information to hand:
The appliance model (Mod.).
The serial number (S/N).
This information can be found on the data plate
located on the appliance and/or on the packaging.
Care and maintenance
! Do not use the oven lamp as/for ambient lighting.

Содержание

Care and maintenance Respecting and conserving the environment You can help to reduce the peak load of the electricity supply network companies by using the oven in the hours between late afternoon and the early hours of the morning Always keep the oven door closed when using the GRILL and DOUBLE GRILL modes This will achieve better results while saving energy approximately 10 Check the door seals regularly and wipe them clean to ensure they are free of debris so that they adhere properly to the door thus avoiding heat dispersion Switching the appliance off Disconnect your appliance from the electricity supply before carrying out any work on it j inoesiT Dirt and grease should be removed from the control panel using a non abrasive sponge or a soft cloth GB Stainless steel can be marked by hard water that has been left on the surface for a long time or by aggressive detergents containing phosphorus After cleaning rinse well and dry thoroughly Any remaining drops of water should also be dried The cover If the cooker is fitted with a cover this cover should be cleaned using lukewarm water Do not use abrasive products It is possible to remove the cover in order to make cleaning the area behind the hob easier Open the cover fully and pull it upwards see figure Do not close the cover when the burners are alig ht or when they are still hot Cleaning the appliance Inspecting the oven seals Do not use abrasive or corrosive detergents such as stain removers anti rust products powder detergents or sponges with abrasive surfaces these may scratch the surface beyond repair Check the door seals around the oven regularly If the seals are damaged please contact your nearest After sales Service Centre We recommend that the oven is not used until the seals have been replaced Never use steam cleaners or pressure cleaners on the appliance Replacing the oven light bulb The stainless steel or enamel coated external parts and the rubber seals may be cleaned using a sponge that has been soaked in lukewarm water and neutral soap Use specialised products for the removal of stubborn stains After cleaning rinse and dry thoroughly Do not use abrasive powders or corrosive substances The inside of the oven should ideally be cleaned after each use while it is still lukewarm Use hot water and detergent then rinse well and dry with a soft cloth Do not use abrasive products Clean the glass part of the oven door using a sponge and a non abrasive cleaning product then dry thoroughly with a soft cloth Do not use rough abrasive material or sharp metal scrapers as these could scratch the surface and cause the glass to crack 1 After disconnecting the oven from the electricity mains remove the glass lid covering the lamp socket see figure 2 Remove the light bulb and replace it with a similar one voltage 230 V wattage 25 W cap E 14 3 Replace the lid and reconnect the oven to the electricity supply Do not use the oven lamp as for ambient lighting Assistance Please have the following information to hand The appliance model Mod The serial number S N This information can be found on the data plate located on the appliance and or on the packaging The accessories can be washed like everyday crockery and are even dishwasher safe 23

Скачать
Случайные обсуждения