Mahlkoenig EK 43 T [16/28] Commercial coffee grinder

COMMERCIAL COFFEE GRINDER

Connecng the potenal equalizer

The connecon for potenal equalizaon (12) is located on the back of the

grinder (see Fig. B). The electrical connecon and tesng of electronic func-

onality must be carried out by an electrician.

1. Loosen and remove the lock nut (see Fig. E).

2. Remove the lock ring and the at washer.

3. Connect the potenal equalizaon conductor (17) to the potenal equalizer.

The potenal equalizaon conductor is not included with delivery.

Use a copper potenal equalizaon conductor with a minimum

cross-secon of 10 mm

If you have quesons about this, contact an authorized service

partner or electrician.

4. Secure the potenal equalizaon conductor by reaaching the nut, at

washer and lock ring.

Operaon

INFORMATION!

Risk of damage!

The operator has no inuence on the thermal overcurrent circuit-breaker.

If the thermal overcurrent circuit-breaker has been triggered several

mes, a service partner must be contacted for advice as the motor

winding can become damaged.

• The grinder has a thermal overcurrent circuit-breaker which

interrupts the electric circuit of the grinder in case of electrical

overload. To put the grinder into operaon again, rst press

the o switch 0 (4) and disconnect the power plug (14). Then

press the release buon (15). You can now plug the power

plug back into the socket and put the grinder into operaon

(see chapter "Seng up the grinder").

• The grinder also has a motor protector, which switches o

the grinder when the motor becomes too hot. As soon as the

motor has cooled down, the grinder can be put into operaon

again (see chapter: “Troubleshoong”).