Beko CSG 52010 X [12/76] Prsr l

Содержание

or door available for room ventilation an extra ventilation must be installed The appliance may be located in a kitchen kitchen diner or a bed sitting room but not in a room containing a bath or shower The appliance must not be installed in a bed sitting room of less than 20m3 Do not install this appliance in a room below ground level unless it is open to ground level on at least one side Room size Ventilation opening smaller than 5 mJ min 100 cm2 5 md to 10 md min 50 cm2 greater than 10 mdlden not required In the cellar or basement min 65 cm2 Installation and connection Product can only be installed and connected in accordance with the statutory installation rules PrSr lD0 L1 not install the appliance next to Jrefri9erators or freezers The heat emitted y the appliance will lead to an Increased energy consumption of cooling appliances Carry the product with at least two persons Product must be placed directly on the floor It must not be placed onto a base or a pedestal ______________________ rJ Material damage L1 d or an or Jrhe handle must not be used mor lifting or moving the appliance Electrical connection Connect the product to a grounded outlet line protected by a fuse of suitable capacity as stated in the Technical specifications table Have the grounding installation made by a qualified electrician while using the product with or without a transformer Our company shall not be liable for any damages that will arise due to using the product without a grounding installation in accordance with the local regulations 11 EN A DANGER Risk of electric shock short circuit or fire by unprofessional installation The appliance may be connected to the mains supply only by an authorized qualified person and the appliance is only guaranteed after correct installation A DANGER Risk of electric shock short circuit or fire by damage of the mains lead The mains lead must not be clamped bent or trapped or come into contact with hot parts of the appliance If the mains lead is damaged it must be replaced by a qualified electrician The mains supply data must correspond to the data specified on the type label of the product The rating plate is either seen when the door or the lower cover is opened or it is located at the rear wall of the unit depending on the unit type Power cable of your product must comply with the values in Technical specifications table E Power cable plug must be within easy reach after installation do not route it above the hob DANGER Risk of electric shock Before starting any work on the electrical installation please disconnect the appliance from the mains supply Plug the power cable into the socket Gas connection DANGER Risk of explosion or poisoning by unprofessional installation The appliance may be connected to the gas distribution system only by an authorized qualified person who is Gas Safe registered