Vitek VT-6403 BK [4/40] English

English

Remote temperature sensor (Pic. 2)

1. LED-indicator

. Battery compartment lid (for  batteries of “ААA” type)

. Sensor re-boot button after changing channel number Тх

4. Switching button between Celsius and Fahrenheit scales C/F

5. Channel switch (1--)

6. Hole for fastening units on the wall

PRECAUTIONS

1. Before operating the units, read the instruction carefully.

. Do not immerse the units into water.

. Do not use abrasives or substances causing damages of the body and inner

parts to clean the units.

4. Do not expose the units to strong physical stress, do not subjects the units

to strikes (dust and moisture are also contraindicated), as it can lead to

failures and correspondingly to the reduction of life time, damages of the

batteries and to the deformation of the body details.

5. Do not dismantle the unit; it will lead to the termination of the guarantee.

There are no parts, requiring attention of the user inside it.

6. Use only new and specified in the manual batteries. Do not use old and new

batteries together.

7. Use the net adapter supplied.

BEFORE OPERATION

Set the remote sensor within effective data transfer radius, and as close as pos-

sible to the base unit. Place the base unit and the remote sensor in places with

minimal interferences for better data transfer. Take into consideration, that the

data transfer radius depends on the construction material of the partitions of the

building and its quantity. Try out several variants of the remote sensor and base

unit placement. In spite of the fact that the remote sensor is protected from me-

teorological conditions, it should be set away from direct sunlight, rain or snow.

House mechanisms (door bell, signal system etc.) can cause interferences for

the reception of data signals from the remote sensor by the base unit. It is nor-

mal and does not influence the general operation. Transfer and reception of the

data signal will resume immediately after the temporary interferences disappear.

Placing batteries in the remote sensor

1. Unscrew the screws on the battery compartment lid.

. Select data transfer channel using the channel switch “1--”.

. Set  batteries (“ААА”, 1.5 V), following the polarity.

4. Close the battery compartment lid and tighten up the screws.

6403IM.indd 4 19.03.2008 14:13:46