Scarlett SC-JE50S45 [5/24] Before using make sure that the lid is fixed firmly

Scarlett SC-JE50S45 [5/24] Before using make sure that the lid is fixed firmly
IM019
www.scarlett.ru SC-JE50S45
5
Remove the transparent lid, pull the grating filter upwards
While doing this, hold it by the beak from below and by the underside of the top of the unit on the other
side.
ASSEMBLING
Before assembling make sure that the juicer is switched off and unplugged.
Place the upper body of the juicer so that it coincide with grooving.
Insert the stainless steel strainer by pushing it till it goes click.
Install the transparent lid and fasten the locks.
Place the juice container under the juice spout.
Place the pulp container under the cover.
Plug the appliance to the power supply.
OPERATION
Before using, make sure that the lid is fixed firmly.
Wash the vegetables / fruits thoroughly. Remove the peel and kernels, cut vegetables and fruits in
small pieces, which are easily have been placed to the feeding tube.
Plug the juicer to the power supply and choose the appropriate speed mode:
Speed I is for the soft products: pears, strawberry, oranges, plums, grapefruits, lemons, grapes.
Speed II is for the products of the middle softness: pears, peppers, pineapples, bush-pumpkin, leek.
Speed III is for hard products: carrot, apple, beet, pineapple.
Load the prepared vegetables/fruits into the juicer and press down gently with the pusher. NEVER
USE FINGERS AS PUSHER.
The motor must always be running after fruit or vegetables were fed into the appliance.
When pulp container or juice jug is full, switch off the power and empty containers before continuing
the process.
Anti-drip must be turned downward on the spout. Once operation is finished anti-drip can be turned
upward so that the juice does not drip on the table.
The appliance cannot be used for preparing the juice of bananas, apricots, mangos, papaya and coco.
When process is completed, place switch button to 0 position, then switch off and unplug the unit.
SELF-CLEANING FUNCTION
The subject juice extractor is equipped with the build-in system for cleaning the filter.
The build-in cleaning system enables easily clean the filter of the juicer after completing the process.
Upon finishing the operation, set up the “Clean” mode and press the self-cleaning button some times.
The special scraper will clean the whole filter at once.
Cleaning effect will be stronger if some water is poured into the juicer (no more than 800 ml.). By the
way, it is necessary to place an empty glass for juice under the spout.
CLEANING
Remove and wash all removable parts in warm soapy water. Rinse filter assembly from under side for
easy removal of residue from strainer holes. Do not use a dishwasher or very hot water.
Do not use steel woods, abrasive cleaners or scouring pad on appliance.
To clean the outside of the motor unit, use a damp sponge.
Never immerse the body in water.
Some vegetables, such as carrots, may cause discoloration of the plastic. Reduce this by washing
parts immediately after use with small amount of non-abrasive cleaner on a cloth, rub gently, then rinse
well and dry.
The grating filter must be replaced as soon as any signs of damage or wear and tear appear.
STORAGE
Store assembled cleaned and dried juice extractor in a dry place.
The symbol on the unit, packing materials and/or documentations means used electrical and
electronic units and battery’s should not be toss in the garbage with ordinary household garbage.
These units should be pass to special receiving point.
For additional information about actual system of the garbage collection address to the local authority.
Valid utilization will help to save valuable resources and avoid negative work on the public health and
environment which happens with incorrect using garbage.

Содержание

Скачать
Случайные обсуждения