GRAPHITE 58G490 Инструкция по эксплуатации онлайн [18/192] 320605

18

damaged or use other, undamaged tool. Once the working tool has been checked and installed,

start the power tool and allow it to work for one minute at maximum speed. Make sure that user

and bystanders stay away from range of the rotating working tool. Damaged tools usually break

during this test.

Ɣ Wear personal protection equipment. Depending on the task, use protective mask that shields

whole face, eye protection or safety glasses. When necessary use anti-dust mask, hearing

protectors, work gloves or special apron that protects against small particles of grinding and

grinded material. Protect eyes against particles produced at work and floating in the air. Anti-dust mask

it only by insulated handle. At contact with live wires all metal parts of the power tool are live too and

may cause electric shock of the operator.

Ɣ Keep power cord away from rotating working tools. Loss of control over the power tool can lead to

cutting or catching the power cord, also hand or whole arm can get into rotating work tool.

Ɣ Never put away the power tool before working tool comes to complete stop. Rotating tool can

contact the surface it is put on, which can cause loss of control over the power tool.

Ɣ Do not carry power tool when it is rotating. Accidental contact of rotating working tool with clothes

may cause its catching and plunging of working tool into operator’s body.

Ɣ Clean ventilation holes of the power tool on regular basis. Motor blower sucks dust into casing and

Ɣ When cutting blade is caught or pinched in material, the blade stops and motor reaction produces

Ɣ If the cutting blade is warped or positioned incorrectly in the object being cut, blade teeth may hit the

upper surface of the material when leaving the material. It will cause sudden raise of the blade and the

Kick back is effect of improper use of circular saw, or wrong operating procedures or conditions, and can be

avoided by observing applicable, below mentioned precautions:

Ɣ Hold the circular saw rmly with both hands in position that allows to resist kick-back. Stand to

the side of the circular saw but not in the line of cutting. Kick back may cause sudden move of circular

saw to the back, but its force can be controlled by operator when appropriate precaution measures are

Ɣ When restarting the saw in the processed material, centre the cutting blade in the kerf and ensure

slide off or cause kick back against the processed material.

Ɣ Support large boards to minimize risk of pinching and kick back of the circular saw. Large boards

tend to bend under own weight. Place supports under board on both sides, close to the cutting line and

close to the board edge.