Tp-Link TD-8817 Инструкция по эксплуатации онлайн [26/69] 16832

TD-8817 ADSL2+ Modem Router User Guide

• Direction: Select this option to specify the RIP direction. None is for disabling the RIP

function. Both means the ADSL Router will periodically send routing information and

accept routing information, and then incorporate them into routing table. IN only means

the ADSL router will only accept but will not send RIP packet. OUT only means the

ADSL router will only send but will not accept RIP packet.

¾ Multicast: Select IGMP version, or disable the function. IGMP (Internet Group Multicast

Protocol) is a session-layer protocol used to establish membership in a multicast group. The

ADSL ATU-R supports both IGMP version 1 (IGMP v1) and IGMP v2. Select “Disabled” to

disable it.

2. Static IP Address

Select this option if your ISP provides static IP information to you. You should set static IP

address, IP subnet mask, and gateway address in the screen below (shown in Figure 4-8).

Figure 4-8

)

Note:

Each IP address entered in the fields must be in the appropriate IP form, which is four IP octets

separated by a dot (x.x.x.x), such as 192.168.1.100. The Router will not accept the IP address if it

is not in this format.

3. PPPoA/PPPoE

Select this option if your ISP requires you to use a PPPoE connection. This option is typically

used for DSL services. Select Dynamic PPPoE to obtain an IP address automatically for your

PPPoE connection. Select Static PPPoE to use a static IP address for your PPPoE connection.

Please enter the information accordingly.