Vitek VT-1203 [4/10] English русский
![Vitek VT-1203 [4/10] English русский](/views2/1044502/page4/bg4.png)
17
HINTS FOR IRONING
1. Sort out the articles to be ironed according to the type of fabric.
This will minimize the frequency of temperature adjustment for dif&
ferent garments.
2. Test ironing a small area on the backside or inside the garment if
you are unsure about the type of fabric. Start with a low tempera&
ture and increase gradually.
3. Wait for about three minutes before ironing heat sensitive fabrics.
Temperature adjustment needs certain time to reach the required
level no matter it is higher or lower.
4. Delicate fabrics such as silk, wool, velour, etc. are best ironed with
an ironing cloth to prevent shine marks.
5. You may need a few times of press to activate the spray, burst and
vertically burst function.
HOW TO FILL WATER
1. Disconnect the iron from mains supply
outlet.
2. Move the Steam Control/Self&Cleaning
Knob to position.
3. Fill water through the water inlet hole.
(See figure 2)
4. Fill up to the 'Max' level marked on the
side of water tank.
Note: For best result, it is advisable to use demineralised water or dis&
tilled water.
Do not use chemically descaled water or any other liquids.
FIRST TIME IRONING
1. Remove any protective films or stickers from the sole plate and the
cabinet.
2. Unwind and straighten the power cord.
3. Fill the water tank with demineralised water or distilled water. (See
How To Fill Water)
4. Connect the iron to a suitable mains supply outlet.
4
FIGURE 2
На ярлыке означает: изделие нельзя гладить!
(например, эластик)
Примечание:
вид ткани
синтетика
синтетика
ацетатволокно
триацетат
с люрексом
полиамид
(нейлон)
полиэстер
вискоза
шелк
шерсть
шерсть
хлопок
хлопок
лен лен
синтетика
акрил
полипропилен
полиэтан
волокно
позиция
терморегулятора
ярлык
шелк
ENGLISH РУССКИЙ
1203.qxd 03.07.03 16:47 Page 8
Содержание
- Модель vt 1203 1
- English 2
- Гарантийный талон 2
- Купон 1 2
- Купон 2 2
- Купон 3 2
- English 3
- English русский 4
- Русский english 5
- Burst of steam this function provides extra amount of steam to remove stubborn wrin kles 1 fill the iron as described in the section of how to fill water 2 turn the temperature dial to 3 dots setting 3 pilot light glows indicating the iron is switched on 4 pilot light goes off when the required temperature is reached 5 the iron is ready for use 6 press the burst of steam button once 7 steam will shoot from the holes of the soleplate into the fabric 6
- Connect the iron to a suitable mains supply outlet 3 turn the temperature dial in clockwise direction to 3 dots setting for optimum steam quality do not use 1 dot or 2 dots set ting for steam ironing 4 pilot light glows indicating the iron is switched on 5 pilot light goes off when the required temperature is reached 6 the iron is ready for use 7 move the variable steam control self cleaning knob to give the desired amount of steam 6
- English русский 6
- Figure 4 6
- Forward for more steam backward for less steam or to posi tion with no steam 8 turn the temperature dial in anti clockwise direction to min the iron is switched off 9 disconnect the iron from mains supply outlet 10 when the iron gets cool completely store it vertically in a safe place 6
- Note set the steam control knob to position after use 6
- Qxd 03 7 3 16 47 page 12 6
- Русский english 7
- English русский 8
- Cleaning the iron 1 disconnect the iron from the mains supply outlet 2 use a damped cloth or non scratching cleaner to remove any deposits on the sole plate or the cabinets note 1 never use sharp or rough objects to remove the deposits on the sole plate 2 never use any abrasive vinegar or descaling agents to clean the iron 9
- Draining the water 9
- Figure 7 9
- Move the steam control self cleaning knob to position 2 disconnect the iron from the mains supply outlet 3 press the burst of steam button to release any trapped water when the sole plate still hot 4 press the spray buttons to release any trapped water 5 hold the iron upside down and gently shake it to remove the remaining water 9
- Note set the steam control knob to position before storing the iron 9
- Particularly during heat up or whilst cooling down this is perfectly nor mal and indicates that the system is functioning correctly 9
- Power requirement 230 v 50 hz max power 1650 w 9
- Qxd 03 7 3 16 47 page 18 9
- Service life of the iron not less than 3 years 9
- Specification 9
- Наполните резервуар водой 9
- Первое использование 9
- Раскрутите шнур 9
- Русский english 9
- Температура глажения 9
- Удалите этикетки с подошвы и корпуса утюга 9
- Qxd 03 7 3 16 47 page 20 10
- Меры предосторожности 10
- Подошва 2 терморегулятор 3 точка указатель терморегулятора 4 индикатор включения 5 отверстие для заполнения водой 6 распылитель 7 регулятор различных режимов отпаривания самоочистки 7а позиция отпаривание 7в позиция сухое глажение 8 кнопка увлажнения 9 кнопка подачи струи пара 10
- Пользуйтесь утюгом только на гладильной доске 10
- Русский русский 10
Похожие устройства
- D-Link DIR-620 Инструкция по эксплуатации
- Epson XP-303 Инструкция по эксплуатации
- Speed-Link SL-6164-SWT Инструкция по эксплуатации
- Samsung SG12DCGWHN Инструкция по эксплуатации
- D-Link DIR-628 Инструкция по эксплуатации
- Epson L210 Инструкция по эксплуатации
- Speed-Link SL-6164-SGY Инструкция по эксплуатации
- Novex ND-9101 Инструкция по эксплуатации
- Epson L355 Инструкция по эксплуатации
- D-Link DIR-632 Инструкция по эксплуатации
- Texet T-425 Инструкция по эксплуатации
- Epson XP-103 Инструкция по эксплуатации
- D-Link DIR-635 Инструкция по эксплуатации
- JVC AV-14FTG2 Инструкция по эксплуатации
- D-Link DIR-645 Инструкция по эксплуатации
- Vitek VT-1202 Инструкция по эксплуатации
- Epson L200 Инструкция по эксплуатации
- D-Link DIR-651 Инструкция по эксплуатации
- Samsung SG06DCGWHN Инструкция по эксплуатации
- Samsung CLX-3305/XEV Инструкция по эксплуатации
Скачать
Случайные обсуждения
Ответы 1
Какие меры безопасности рекомендуется соблюдать при использовании парового утюга?
1 год назад