D-Link DGS-6604 — руководство по установке управляемого коммутатора Ethernet [85/111]

Превью страниц Страница 85 / 111

DGS-6600 Layer 3 Chassis Ethernet Managed Switch Hardware Installation Guide

First Time Connecting to the Switch

The Switch supports user-based security that provides prevention of unauthorized access to the Switch or

change of settings. This section explains how to log onto the Switch via an out-of-band console connection or an

out-of-band Management port connection.

Upon initial connection to the Switch, the login screen appears (see Figure 4-2).

Figure 4-2 Initial screen first time connecting to the switch

There is no initial login procedure until at least one user is created through the CLI Command Interface. The

Switch will automatically login to the User Exec level. To gain access to enter the configuration mode use the

following command:

The enable command enters the user into the Privileged EXEC mode (administration rights) and the configure

terminal enters the user into the Global configuration mode.

rip ...

dvmrp ...

pdm ...

ospf6 ...

pim ...

ripng ...

dhcpr4 ...

dhcps4 ...

dhcpc4 ...

web ...

time ...

dhcpc6 ...

dhcpr6 ...

sflow ...

devinfo ...

acl ...

ospf ...

DGS-6600 Chassis-based High-Speed Switch

Command Line Interface

Firmware: 3.00.048

DGS-6600:2>

DGS-6600:2>enable

DGS-6600:15#configure terminal

DGS-6600:15(config)#

NOTE: The initial login automatically gets Administrator level (Privileged EXEC) privileges

until a user is created if the user does not have Privileged EXEC rights then an Enable pass-

word should be set). It is recommended that at least one Admin-level user account should

be created for the Switch.