Cyberpower CPS1500PIE [4/19] Copyright 2014 cyberpower systems inc

CPS1500PIE

INSTALLING YOUR EPS

Installing your EPS

UNPACKING

Inspect the EPS upon receipt. The box should contain the following:

EPS unit x 1; Installation Guide x 1; User manual x 1

AUTOMATIC VOLTAGE REGULATOR

When utility power is inconsistent, the EPS would increases low voltage or decrease high voltage to safe

220 volts. The EPS automatically provides battery backup (External battery connection required) if the

voltage drops below 140 volts or exceeds 300 volts.

HARDWARE INSTALLATION GUIDE

1. Your new EPS may be used immediately upon receipt. However, recharging the external battery for at

least 12 hours is recommended to ensure that the battery’s maximum charge capacity is achieved

(Charging time varies with capacity and a 100AH or greater battery is recommended). To recharge the

external battery, simply leave the unit plugged into an AC outlet. Your EPS is equipped with an

auto-charge feature. When the EPS is plugged into an AC outlet, the external battery will automatically

recharge. The unit will charge in both the ON and OFF positions.

2. DO NOT plug a laser printer, paper shredder, copier, space heater, vacuum or other large

electrical device into the EPS. The power demand of these devices may overload and damage

the unit. DO NOT use with medical or life support equipment. DO NOT use with or near

aquariums as condensation may cause the unit to short.

3. After connecting the hard wires, plug the EPS into a 2 pole, 3 wires grounded receptacle (wall outlet).

Make sure the wall branch outlet is protected by a fuse or circuit breaker and does not service

equipment with large electrical demands (e.g. refrigerator, copier, etc…). The warranty prohibits the

use of extension cords, outlet strips, and surge strips.

4. Press the power switch to turn the unit on. The power on indicator light will illuminate and the unit will

beep once.

5. If an overload is detected, an audible alarm will sound and the unit will emit one long beep. To correct

this, turn the EPS off and unplug at least one piece of equipment from the battery power supplied

outlets. Wait 10 seconds. Make sure the circuit breaker is depressed and then turn the EPS on.

6. To maintain optimum battery charge performance, make the EPS plugged into an AC outlet at all times.

Enabling the switch provides the bypass for charge only.