Philips AC2721/10 [17/98] Installing the antibacterial cartridge

Philips AC2721/10 [17/98] Installing the antibacterial cartridge
15EN
English
6 Place the new NanoCloud rotary
humidication wick in the wick
wheel, and then fasten the locks on
the wick wheel (g. ).
7 Place the wick wheel on the wick
support (g. m).
Note
When placing the wick wheel on the
wick support, make sure that the
projections on the wick wheel falls
into the corresponding grooves.
8 Place the water tray and water tank
back into the appliance (g. n).
9 Touch and hold for 3 seconds
to reset the NanoCloud rotary
humidication wick lifetime counter.
Installing the
antibacterial cartridge
Note
The antibacterial cartridge is not
supplied, you can purchase it by
contacting the Philips Consumer
Care Center in your country or visit
www.philips.com.
Following the following steps to install
the antibacte
rial cartridge
(
FY
5131).
Replace the antibacterial cartridge at
least once a year to prevent bacteria
from growing in the water tray.
1 Take the wick wheel o the wick
support (g. ).
2 Remove all packaging materials of the
new antibacterial cartridge (g. ).
3 Place the new antibacterial cartridge
into the water tray and push it
horizentally into the slot (g. ).
4 Place the wick wheel on the wick
support (g. m).
5 Place the water tracy and water
tank back into the appliance.
1 Remove the used lters from the
appliance (g. Œ).
Note
Do not touch the pleated lter
surface, or smell the lters as they
have collected pollutants from the air.
Wash your hands after disposing of
the used lters.
2 Remove all packaging material of
the new lters (g. f).
3 Place the new lters into the
appliance (g. g).
4 Touch and hold for 3 seconds to
reset the NanoProtect lter lifetime
counter.
Replacing the
NanoCloud rotary
humidication wick
Filter alert light status Follow this
F1 is displayed and
the lter replacement
light ashes on the
screen (g. ).
Replace the
NanoCloud
rotary
humidication
wick
1 Take the wick wheel o the wick
support (g. ).
2 Grip the shaft screw on the
other side of the wheel, rotate it
anticlockwise to release the wick
from the wheel (g. ).
3 Unfasten the locks on the edge
of the wheel successively to
disassemble the wick wheel (g. ).
4 Take the used NanoCloud rotary
humidication wick out (g. ).
5 Remove all packaging material
of the new NanoCloud rotary
humidication wick (g. l).

Содержание