Home
Главная
Murray
Снегоуборщик
MS 55800 E
Руководство пользователя Страница: 17

Murray MS 55800 E [17/224] Change the oil

Snowthrower

After Each Use

Remove accumulated snow and slush from the unit to prevent

freezing of controls.

Every 8 Hours or Daily

Perform impeller safety tests.

Every 25 Hours or Annually

Check snowthrower for loose hardware.

Adjust auger control cable if necessary.

See Dealer Annually to

Z##

Engine

First 5 Hours

Change oil.

Every 8 Hours or Daily

Check engine oil level.

Every 50 Hours or Annually

Change engine oil.

X

Annually

Replace spark plug.

Check valve clearance. *

* Not required unless problems are noted with engine

performance. See authorized dealer.

Emissions Control Statement

Maintenance, replacement, or repair of the emissions

control devices and systems may be performed by any

non-road engine repair establishment or individual.

However, to obtain “no charge” emissions control service,

the work must be performed by a factory authorized dealer.

Change the Oil

Remove Oil

Used oil is a hazardous waste product and must be

disposed of properly. Do not discard with household waste.

Check with your local authorities, service center, or dealer

for safe disposal / recycling facilities.

1. With engine off but still warm, disconnect the spark plug

wire (A, Figure 11) and keep it away from the spark

plug.

NOTE: To access the spark plug wire, you must first

remove the snow hood from the engine. See Replace

the Spark Plug in this section.

2. Tilt the unit back slightly, then remove the oil drain cap

(B, Figure 12). Drain the oil into an approved receptacle.

3. After the oil has drained, install and tighten the oil drain

cap.

Add Oil

1. Place engine level.

2. Clean the oil fill area of any debris.

3. See Specifications section for oil capacity.

4. Remove the dipstick (C, Figure13) and wipe with clean

cloth.

5. Pour the oil slowly into the engine oil fill (D). DO NOT

overfill. Wait one minute and recheck the oil level.

6. Install and tighten dipstick.

7. Remove the dipstick and check the oil level. It should be

at the top of the full indicator (E) on the dipstick.

8. Install and tighten dipstick.

Maintenance

Not for

Reproduction

Murray MS 55800 E [17/224] Change the oil

Содержание

Похожие устройства