Sdmo TECHNIC 10000 E AVR [11/24] Maintenance table
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Sdmo TECHNIC 10000 E AVR [11/24] Maintenance table

Sdmo TECHNIC 10000 E AVR [11/24] Maintenance table
6.2. Maintenance table
Component
Operations to be
carried out when
the expiry date is
reached
Each time
it is used
After:
1 month
Or
the first 20 hours
Every
month
Every
3 months
Or
every 60
hours
Every
5 months
Or
every 100
hours
Every
Year
Or
every 500
hours
Screws and bolts Check
•
Engine oil
Check the level
•
Change
•
•
Oil filter Replace
•
•
Fuel filter
Check
•
Replace
•
Air filter
Check
•
Clean
•
Starter battery Check
•
•
Spark plugs
Inspect
•
Replace
•
Generating set Clean
•
Valves * Check*
•*
Combustion
chamber*
Clean*
•*
* Operation(s) to be entrusted to one of our dealers.
If used in dusty conditions, clean the air filter more frequently.
If in regular use, change the oil at least every year.
7. Maintenance procedures
Before carrying out any maintenance operation:
- switch off the generating set.
- disconnect the cap(s) of the spark plug(s) and disconnect the starter battery (if fitted).
Warning
Only use original parts or equivalent parts: risk of damage to the generating set.
7.1. Checking bolts, nuts and screws
To prevent faults or breakdowns, carefully check all the nuts, bolts and screws on a daily basis.
n Inspect the entire generating set before and after each use.
o Tighten any loose nuts or bolts.
Danger: The cylinder head bolts must be tightened by a specialist. Refer to the agent for your region.
7.2. Renewing the motor oil
Observe the environmental protection regulations (see § Environmental protection) and drain the oil into an appropriate container.
n Whilst the engine is still warm, place a suitable container underneath the oil drain plug (fig. A - mark 12), then remove the oil filler
cap (fig. A - mark 2) and the oil drainage plug.
o When the sump is completely empty, screw back the oil drainage plug.
p Fill-up with the recommended oil (see § Specifications), check the level (see § Checking the oil level).
q Replace and screw down the oil filler cap.
r After filling, check that there are no oil leaks.
s Wipe away any traces of oil with a clean cloth.
7.3. Replacing the oil filter
n Drain the engine oil (see § Changing the engine oil).
o Remove the oil filter (fig. A - mark 13) and dispose of it.
p Clean the oil filter support and coat oil filter seal with clean engine oil.
q Re-install a new oil filter.
r Screw-in the filter manually until the seal arrives at the end-stop and then screw it a further 1 ¾ turn or tighten it down with a torque
wrench (22 N.m).
s Refill with the specified amount of oil (see § Specifications).
t Check the oil level (see § Checking the oil level) and ensure there are no leaks.

Содержание

Похожие устройства

Скачать