Dometic CFX 75DZW [21/372] Using the emergency switch

CFX75DZW, CFX95DZW Operation

7.9 Set brightness of displays

The display brightness can be dimmed for low ambient light conditions. To set the

dimming level of the display proceed as follows:

➤ Switch on the cooler.

➤ Press the “SET” button (fig. 3 4, page 2) five times.

➤ Use the “UP +” (fig. 3 7, page 2) or “DOWN –” (fig. 3 6, page 2) buttons to

set the brightness of the displays.

✓ Display will be as follows:

d0 (default), d1 (medium), d2 (dark)

✓ The displays show the set mode for some seconds. The displays flash several

times before they returns to the current brightness.

7.10 Using the emergency switch

The emergency switch (fig. 4 3, page 3) is located below the control panel. For

normal operation the switch is in the “NORMAL USE” position.

➤ If an electronic control failure occurs, slide the switch to “EMERGENCY

OVERRIDE” position.

NOTE

• The factory setting of brightness of the display is d0 (default).

• If a fault occurs, the brightness automatically is d0 (default). After

troubleshooting the set brightness is reactivated.

NOTE

If the switch is in the “EMERGENCY OVERRIDE” position, the cooler

circuit runs with full cooling capacity and, depending on the running

conditions of each compartment at the time of switching, may either

freeze one or both compartments, and/or stop cooling one of the

compartments.

CFX75_95DZW--O-16s.book Seite 21 Montag, 14. August 2017 4:29 16