Qtech QSW-8200-28T-AC-DC [33/36] Ulpp flush enable mac vlan

User Manual

Chapter 4. Commands for ULPP 33

www.qtech.ru

 Usage Guide: Enable receiving the flush packets of updating MAC address table.

 Example: Enable receiving the flush packets of updating the MAC address.

 Switch(config)# interface ethernet 1/0/1

 Switch(config-If-Ethernet1/0/1)# ulpp flush enable mac

4.26 ulpp flush enable mac-vlan

 Command: ulpp flush enable mac-vlan

 Function: Enable receiving the flush packets of mac-vlan type.

 Parameter: None.

 Default: Disable.

 Command mode: Port mode.

 Usage Guide: If enabling this function, configure the interface to receive the flush

packets handled mac-vlan type and delete the dynamic unicast mac according to vlan

information in the packets.

 Example: Enable receiving the flush packets deleted by mac-vlan of port.

 Switch(config)#interface e1/0/2

 Switch(config-if-ethernet1/0/2)#ulpp flush enable mac-vlan

4.27 ulpp group

 Command: ulpp group <integer>

 no ulpp group <integer>

 Function: Create a ULPP group. If this group exists, then enter the configuration mode

of ULPP group. The no command deletes a ULPP group.

 Parameter: <integer> is the ID of ULPP group, range from 1 to 48.

 Command mode: Global Mode.

 Default: Any ULPP groups are not configured.

 Usage Guide: None.

 Example: Configure ulpp group 20 or enter the mode of ulpp group 20.

 Switch(config)# ulpp group 20

 Switch(ulpp-group-20)#

4.28 ulpp group master

 Command: ulpp group <integer> master

 no ulpp group <integer> master

 Function: Configure the master port of ULPP group, the no command deletes the

master port.

 Parameter: <integer> is the ID of ULPP group, range from 1 to 48.

 Default: There is no master port configured by default.

 Command mode: Port mode.